Technical Bulletin

www.panduit.com
Key Features Benefits
Dual cycle design
Conductors are flush cut and seated within wire cap in one cycle; wire cap and
jack module assembled with additional cycle, eliminating the use of two field
termination tools
Terminates all TG style jack
modules
Single-handed operation and
ergonomic design
Tool is comfortable and easy to use; reducing operator fatigue and repetitive motion
injuries; improve productivity by terminating jack modules in 25% less time than
traditional field termination
Conductors retained
Cut-off conductors are retained for easy disposal; increases productivity by
eliminating need to clean up work area after terminations
Consistent terminations
Reduce on-site rework due to properly and consistently seating conductors and
wire cap into jack
Robust design
Cycle tested up to 2500 terminations
Only one tool is required to terminate all TG style jack modules, reducing the number
of tools required in the field
Automatic release
Tool spring design eliminates the need to reset tool for next jack
module termination
The TG termination tool enables single-handed termination of all UTP and
STP TG jack modules in significantly less time compared to traditional on-site
methods. Ergonomically designed to improve productivity, the tool ensures
consistent termination, lowers installation costs, and reduces field termination
tools. The TG termination tool seats and flush cuts 4-pair conductors in one
motion and assembles the wire cap and jack, completing jack termination in
two quick cycles. Combined with bulk packaged jack modules, Panduit
delivers the highest performance copper connectivity solution at the
lowest installed cost.
TG Termination Tool
Conductors are flush cut and seated
within wire cap in one cycle and
retained for easy disposal.
Wire cap and jack module are
assembled with additional cycle.
Dual Cycle Design