HOME MONITOR User Manual OV2411N The features & specifications described in this user’s guide may be subjected to modifications without prior notice.
OV2411N HOME MONITOR Safety Instructions WARNING This home monitor is compliant with all relevant standards regarding Guide, safe to use. Therefore, always read the instructions in this User’s Guide carefully before using the device. - This product is not a toy. Do not allow children to play with it. - Keep this user’s guide for future reference. - Keep the cords out of reach of children. - Test the home monitor before use. Become familiar with its functions and features.
OV2411N HOME MONITOR 1.1 Overview of OV2411 Viewer 114 6 7 15 1 2 8 3 9 4 10 5 11 13 16 12 17 1. Up /Talk Key 2. Enter Key 3. Cam 1 Key 4. Cam 2 Key 5. Left Key /Volume Down 6. Signal LED 7. Display 10. Cam 4 key 11. Right /Volume up 12. Down /Snapshot 13. SD Slot 14. String holder 15. Battery cover 16. Speaker 17. USB power plug 9. Cam 3 Key 1.2 Keys All ovizee handset operation are done with the following keys : Power, Menu, Enter, Cam1, Cam2, Cam3, Cam4, Up, Down, Left, Right.
OV2411N BABY MONITOR 1.3 Overview of Ovizee Camera 4 1 7 2 6 3 5 1. Power LED 2. Infrared LEDs 3. Light Sensor 4. Camera lens 5. Microphone 6. Speaker Push the ON/OFF switch down to switch on the camera. The Power LED indicator will turn on. There is no setup involved. Just plug-in power and it will start working. For additional camera, pairing procedures must be done before usage, please refer 2.1 for details.
OV2411N HOME MONITOR 2.1 Camera unit power supply 1. Connect the small plug of the AC adaptor to the baby unit and the other end to the mains socket (230V/50Hz). NOTE Only use the enclosed power adapter (5V DC / 1000mA). 2. Push down the power switch to switch on the baby unit. The power LED will light up in green. P.
OV2411N HOME MONITOR 2.2 Vision unit battery installation 1. Insert the wire tab of the rechargeable battery pack into the contact 2. Close the battery compartment and tighten the screw in a clockwise direction. - It will take a few seconds to start up the unit. The battery icon indicates that the battery pack is low and needs to be recharged. The battery pack takes about 15 hours to charge fully. BL-5C lithium battery P.
OV2411N HOME MONITOR 2.3 Vision unit power supply IMPORTANT Install the rechargeable battery pack before connecting the AC power supply. 1. Connect the small plug of the AC adaptor to the parent unit and the other end to the mains socket (230V/50Hz) NOTE Only use the enclosed power adapter (5V DC / 1000mA).. 2. The LCD screen illuminates and starts up automatically after a few seconds. 3. Press and hold Enter to turn OFF the parent unit.
OV2411N HOME MONITOR 2.4 First time installation done before normal operation (Note: Devices comes with Camera/Viewer pair needs no pairing as they are already pre-paired in the factory). Choose the zone for paring by pressing ZONE1 to ZONE4. Press
OV2411N HOME MONITOR 3.1 Select Camera (Zone) press to go to video zone 1, press to go to video zone 2, press to go to video zone 3, press to go to video zone 4. The corresponding video and audio will be activated. Zone1 Zone3 Zone3 Zone4 3.2 Speaker Volume Control to decrease volume or press to increase. Continue pressing will mute the speaker. Left right P.
OV2411N HOME MONITOR 3.3 Talk function(Vision to Camera) Press to set two ways audio, a “Talking” icon will be showed on the top of the display. Hold this key to continue talking. Release the key after speaking. Up/Talk 3.4 Snap-shot Function (Handheld to Camera ) Press to take one photo on current display. The photo will be stored on the Micro-SD card. Note that a mini-SD card is needed ( not-supplied ) for this function. Down/Snap P.
OV2411N HOME MONITOR Press
OV2411N HOME MONITOR 3.7 Voice Trigger/Wakeup Press
then and to select voice trigger function. Press or to choose VOX level Right mode= Maximum volume to turn on the camera If voice trigger is detected by the camera, the PandaVision Viewer will automatically switch to the camera even it is viewing other channel or standby. * note that VOX setting can set on individual camera 3.OV2411N HOME MONITOR 3.9 Memory-card Photo-viewer Ovizee handset supports snap-shot function if a micro-SD card ( < 2GB ) is present. ( The Micro-SD card should be FAT16 or FAT32 pre-formatted ) All photo will be stored in the order PV000000 to PV999999, under the directory “OVIZEEVIS” Press to go to photo-viewer function, the most updated photo will be displayed. Press and to review last and next photo. Press to quit photo-viewer function 3.
OV2411N HOME MONITOR FCC and IC regulations FCC Part 15 NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the Federal Communications Commission (FCC) rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
OV2411N HOME MONITOR WARNING by the party responsible for compliance could void the user’s authority to operate the equipment. Industry Canada Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
OV2411N HOME MONITOR des parties responsables de l’homologation peut retirer à l’utilisateur son droit d’utiliser l’appareil. Cet appareil est conforme à l’article 15 de la FCC. Le fonctionnement est soumis aux deux conditions suivantes: (1) Cet appareil ne doit pas causer d’interférences nuisibles et; (2) Il doit pouvoir supporter les parasites qu’il reçoit, incluant les parasites pouvant nuire à son être assurée avec cet appareil.
OV2411N HOME MONITOR Disposal of the device (Environment) At the end of the product lifecycle, you should not dispose of this product with normal household waste, but take the product to a collection point for the recycling of electrical and electronic equipment. The symbol on the product, user’s guide and/or box indicates this. Some of the product materials can be re-used if you take them to a recycling point.
OV2411N HOME MONITOR Baby unit Frequency : Maximum range : Image sensor : Lens: IR LED : Power : 2.4GHz to 2.4835GHz 150m Line of Sight Colour CMOS f 2.5mm, F 2.8 9 pcs Adapter: DC5V, 1000mA (Model: Helms-Man, SCB0501000P or Helms-Man, SHB0501000PE) Battery: Li-Polymer rechargeable battery (Model:TFL703048) WARNING Do not use non-rechargeable batteries for the Parent Unit. Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.
OV2411N HOME MONITOR Manufactured, distributed or sold by Pandachip Limited, the owner of OVIZEE and the Stylized OVIZEE Logo, and other OVIZEE trademarks and trade dress. OVIZEE and the Stylized OVIZEE Logo are registered in the HK Patent & Trademark are the property of their respective owners. © Pandachip Ltd. 2009. All rights reserved. Version 1.