Installation guide

ISTEP1

Stack the components as shown below.

,Tuner

Amplifier

Graphic equalizer

Casse_e deck

CD changer

Before connecting each unit, check and identify the supplied

accessories comparing to the illustrations at the top of each

step (steps 2--5).

RQC_,A0522

H1096G0

PAGE 1
I STEP 1 Stack the components as shown below. ,Tuner Amplifier Graphic equalizer Casse_e deck CD changer i Before connecting each unit, check and identify the supplied accessories comparing to the illustrations at the top of each step (steps 2--5).
PAGE 2
STEP 2 5 (6 pcs.) When these terminals are not in use, be sure to insert the "shorting" pins.
PAGE 3
STEP 3 D % : .....
PAGE 4
STEP D Included Included with the front speakers (2 pcs.) Included with the center speaker (1 pc.) surround with the speak#rs (2 pcs.) j F Front speakers How to place speakers The Dolby Pro-Logic effect is best enjoyed when you are seated as shown in figure below.
PAGE 5
STEP 5 D % Long thick (2 pcs.) Short thin (3 pcs.) Short thin ] Short thin I Connect this cord after all other cables and are connected.
PAGE 6
Check the installation by tuning in the radio first The explanationbelowis an exampleof operationin the case where the frontspeakersare beingusedfor checkng..If the center speakerand/orsurroundspeakersare beingusedto enjoythe DolbyPro Logicsystemor SFC function, refer to pages 38-41 of the operatinginstructions. 3 Press POWER. Press TUNER. Press SI_EAKERS. "SPEAKERS"will illuminate, .... If the "TAPE MONITOR" indicatoris illuminated, pressthisbuttonto turn the indicatoroff.