DDS BACKUP LIBRARY LKM-SD21-S INSTRUCTION MANUAL Please read through these instructions before operating this unit.
IMPORTANT SAFETY NOTICE NOTICE (1) You may not reproduce or transcribe any part of this publication without permission. (2) We reserve the right to revise this document at any time without notice. (3) If you have any questions about this document, contact your sales representative. SAFETY NOTICE (1) To prevent fire or electric shock, do not expose this appliance to rain or moisture. (2) To avoid electric shock, do not attempt to disassemble the cabinet.
IMPORTANT SAFETY INSTRUCTIONS 1. 2. 3. 4. Read all of these instructions. Save these instructions for later use. Follow all warnings and instructions marked on the product. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. 5. Do not use this product near water. 6. Do not place this product on an unstable rack, cart, stand, or table. The product may fall, causing serious damage to the product. 7.
KIT CONTENTS ■ DDS Backup Library Unit ■ Power Cable ■ Safety Instruction Manual This product can be used with the attached power cable only. Recommended Kits ◆ SCSI Interface Board Adaptec SCSI narrow (AHA-2940 series) ◆ Terminator (for SCSI daisy Chain) P/N: ACK-68 TERM KIT (1718100) ( by Adaptec ) ◆ Rack Please use the suitable rack for this Library.
PARTS AND FUNCTIONS Front View ➀ ➂ ➁ ➃ ➄ ➅ ➆ ➇ ➈ ➉ ➀ Rack Mount Plate For mounting to the rack ➁ Air Flow Hole ( for absorption ) 11 12 Not be blocked or covered to protect this Library from overheating ➂ Cartridge Insertion Portion ( Door ) Trough hole for setting/ ejecting cartridge tape to/from the Library ➃ LCD Display Displays the Garage/ Cartridge-tape and the Library operating status, and Menu mode screen. This has a backlight function.
Rear View ➀ ➁ ➂ ➃ ➀ Power On/Off Switch ➁ Power Connector Connect the attached power cable ➂ Fan / Air Flow Hole ( for release ) Not be blocked or covered to protect this Library from overheating ➃ SCSI Interface Connector Connect the SCSI interface cable ( 68-pin half pitch type ) – If this Library is a terminal device on the SCSI bus, connect the proper terminator to the other (vacant) connector.
CONNECTING Please connect the power and SCSI interface cable to the rear of the Library as follows. Before you begin the below connecting steps, make sure that the host PC and the library Power switch is OFF. ( Recommended the host PC power cable is unplugged ) ➀ Connect the SCSI interface cable to the Library. ➁ Connect the other end of SCSI interface cable to the host PC's SCSI connector. ➂ Connect the attached power cable to the Library and AC outlet. ➃ Switch the Library power ON.
SPECIFICATION SUMMARY GENERAL PERFORMANCE ➀ Power rating ➁ Dimensions (W x H x D) ➂ Weight 120 – 240 V ~ AUTO 0.5 – 0.28 A 50 / 60 Hz 430 x 44 x 650 mm 11.5 kg [ typical ] ENVIRONMENTAL CONDITIONS ➃ Temperature Operating: 5~40 °C ➄ Humidity Operating: 20~80 %RH (Max. wet bulb temp. is 26 °C, Non-condensation) Non-operating: – 40~65 °C Non-operating: 0~90 %RH (Non-condensation, No cartridge tape) Weight and dimensions shown are approximate. Specifications are subject to change without notice.