Panasonic. Personal Computer OPERATING INSTRUCTIONS CF-27 series Contents | Getting Started Read Me First... First-time Operation Getting Started # Operation Starting Up/Shutting Down Starting Up Using the Touch Pad Shutting Down {power off your computer) About the Reference Manual Handling and Maintenance Operation [Additional Manual] Troubleshooting Reference Manual List of Error Codes This manual can be accessed on your computer.
Addendum for Using GSM Model This manual contains supplementary instructions regarding the use of the computer. It explains the cas: computer differs from that in the OPERATING INSTRUCTIONS. s where the operation of the Read Me First For U “OPERATING INSTRUCTIONS (page 3) [Replace as follows. Federal Communications Commission Radio Frequency Interference Statement Note: This equipment has been tested and found to comply with fora Class B digital device, pursuant to Part 15 of the FCC Rules.
[ The {allowing function has been added. ] Your computer is equipped with GSM enabling you to communicate using radio frequencies. @ Front Panel Description WIRELESS SN=a OH GSM Switch The modem powers up independently from the computer regardless of the computer power status and will remain on when the computer is power off, Power On Indication Green: A green LED will be used to signal when the modem has been powered on. ‘The LED will flash when the modem has received a ring.
2 Customer's Record Model No.” Dealer's Name Serial No, or Code No. Dealers Address Product 1D? Date of Purchase ST *! For the Model No. insert the 12 digit number (for example, CF-27FCCKFAM) located on the bottom of the computer. *¢ For Product ID, record the Product ID shown on the “Certificate of Authenticity” located on the bottom of the computer or on the cover of the Windows book (provided with this computer). introduction Thank you for purchasing the Panasonic computer.
Federal Communications Commission Radio Frequency Interference Statement Note: This equipment has been tested and found to comply with the limits for a Class B digital device. pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Lithium Battery! This computer contains # lithium battery to enable the date, time, and other data to be stored. The battery should only be exchanged by authorized service personnel. Warning! A risk of explosion from incorrect installation or misapplication can possibly occur.
Precautions (Battery Pack) ® Care should be exercised with regard to the following in order to avoid the possibility of liquid leakage, overheat ing, or bursting. Av aid Heat Do not throw the battery pack into 2 fire or expose i to excessive heat, Keep Articles Away Do not place the battery pack together with articles such as necklaces or hairpins when carrying or storing. De Not Disassemble Deo not insert sharp objects into the battery pack, expose it to bumps or shocks, deform, disassemble, or modify it.
Saving Data on the Hard Disk # Do not expose your computer to shock. Please use care when handling your computer, shock may damage your hard disk or make your software applications and data unusable. ® Do not power off your computer while software applications are running or HDD indicator (£3) is on. Property shut Windows down to avoid problems (| Start] [Shut Down] ). @ Save afl valuable data to floppy disks.
Getting Started Read the steps below to help you learn what parts are included, and to gain an understanding of some basic computer-related operations. 1 Confirm the inclusion of all parts Make sure the parts shows in the figure have been supplied. If any of these items are missing ot is not waking properly, contact Panasonic Technical Support. (5 page 10) 2 write down the Product ID The Product IDs necessary daring the setup proceeding for.
Getting Started 10 The power saving function is factory set, so if there is no input from the keyboard, touch pad, touchscreen or external mouse far two minutes, the LCD is powered off (ECO mode CF Reese "Computing On The Road” In the ECO mode the LCD will resume operation when the touch pad is used, or when a key or the touchscreen is pressed. The computer may enter the ECO mode while Windows is setting up or even when an application software is being installed.
setup Windows Moving the cursor (fy) or clicking buttons can be performed with the touch pad, a key or the touchscreen. (Cr page 17, Cr Kim “Touchscreen” (I) Select settings for your region, then press (Next]. (2) Select your keyboard layout, then press [Next]. (for U.S.A: United States 101) (3) Enter your name and your company’s name, then press [Next]. (It is possible to omit the company name item.} The License Agreement will be displayed.
Moving the cursor yy or clicking buttons can be performed with the touch pad.{ G+ page 17) The Software License Agreement will be displayed. After reading the agreement, select [I Agree} or (1 Disagree]. (@ Select [Next]. (@ Input your name and organization. then select [Next]. (It is possible to omit the organization item.) @ Input the Product 12 written down in the “Customer's Record” section (CF pages 2.8), then select [Next]. To move the cursor to a particular item, press CRAB) or click the desired box.
Select [Next] at the [Card Executive 2.0 for NT Diagnostics]. Lo NOTE ) The diagnostics may take about two minutes. Select [Next], then select [Finish] Windows will restart Select "Windows NT Workstation Version 4.00" and press . The [Begin Logon] display will appear. Perform the operation in step (g) @ Double-click the [Internet Explorer] icon to install Internet Explorer. Follow the on-screen instructions.
Getting Started 14 1 71 Partition the Hard Disk The hard disk includes an NT file system (FONTS) partition of 4GB. The remaining free hard disk space can be used when necessary by creating more partitions (in grams}-{ Administrative Tools Administrator]). CAUTION (This concludes the first-time use operation guidelines. ) ‘When using the files in the following folders available on the retail version of the Windows CD-ROM, it is necessary to run a separate file decompression program. ‘admin ‘help \data link ‘
Power Switch 1 Open the display (page 9) 2 Turn your computer on Tide the power switch toward the rear of the computer and hold it for approximately one second until the power indicator turns on before releasing it. En Closing the display. “If the display i8 Closed while Windows etc., will not be displayed properly Run the MS-DOS] grains] MS-DOS Port) od use Full screen dispel (Enter). After returning from the full screen ode.
Operation 16 @ If security indicator (ig) is displayed, you must first enter your password, (7 Ree “Security Measures") Upon entering your password | and pressing(Enter). = if the correct password is input, Wil Start Over three incorrect attempts, or no password is entered for about a minute, (— Will Not Start* {Power off) # If you are starting {row the suspend or hibernation mode (C3 IEEE “Suspend/Hibernation Functions).
Work Surface Right Button Left Button Use the touch pad to move the cursor on the display and perform normal computer operations. Basic Operation Moving the Cursor Move the tip of your finger lightly over the surface. Tapping/Clicking Double-Tapping/ Doubt-Clicking Dragging Two quick taps. but Ot While holding down the the second tap leaving bunion, moving your fin your finger down (applier on the work surface ing pressure} and moving it on the work surface.