Manualshelf

User Manual

ManualsBrandsPanamax ManualsElectronicsSmartPLUG w/ BlueBOLT® Control and Monitoring & ZigBee® Wireless Communication (2 Controlled Outlets)
12
SP-1000
Quick Start Guide
www.panamax.com
www.mybluebolt.com www.furmansound.com
POWER / NETWORK
POWER
NETWORK
B
®
NET. ZIGBEE
NET. ZIGBEE
This device complies with part 15 of the FCC Rules. Opera-
tion is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
This equipment has been tested and found to comply with
the limits for a Class B digital device in accordance with the
specifications of Part 15 of FCC rules. These specifications
are designed to provide reasonable protection against such
interference win a residential installation.
However, there is no guarantee that interference will not
occur in a particular installation.
POWER STATUS INDICATOR LIGHTS
POWER ON/OFF and NETWORK CONNECTION STATUS INDICATORS
OUTDOOR USE IS PROHIBITED!
In accordance with FCC 15.21, changes or modifications not
expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
POWER / NETWORK
POWER
NETWORK
POWER / NETWORK
POWER
NETWORK
BOTTOM OUTLET
GROUND PIN RECEPTACLE
FACING WALL OUTLET
TOP VIEW BOTTOM VIEW
INSTALLATION
1. Turn OFF the equipment that you are plug-
ging into the SP-1000.
2. Plug SP-1000 into the wall outlet.
Press the POWER /NETWOK button.
The blue POWER LED indicates power
is on.
3. Plug your equipment into the AC outlets and
turn ON your connected equipment.
4. If the NETWORK LED is GREEN,
the SP-1000 is connected to a ZigBee
network.
If the NETWORK LED is OFF, the
SP-1000 is not connected to a ZigBee
network. Proceed to step 5,
JOIN NETWORK SETUP.
5. Verify that a BB-ZigBee Gateway is powered
on and the SP-1000 is within 100 ft.
JOIN NETWORK SETUP
6. Through the BlueBOLT interface, enable
NETWORK JOINING. Refer to the user manual
for BB-ZIGBEE for detailed instructions.
Multiple SP-1000 units can be installed within 100 ft. from an active ZigBee device (BB-ZIGBEE Gateway, MD2-ZB or another SP-1000).
SP-1000
SP-1000
SP-1000
7. To indicate that the unit has not
joined the network, the NETWORK
LED is OFF.
8. To initiate device discovery, the
POWER / JOIN NETWORK button
is presseed for 5 seconds. While
the unit is attempting to join the
ZigBee HA network, the NETWORK
LED is illuminated YELLOW.
9. After the unit has succesfully
joined the ZIGBee HA network, the
NETWORK LED is GREEN.
If unit fails to join the network after 10
seconds, repeat steps 5 through 9.
BB-ZigBee Gateway
POWER / NETWORK
POWER
NETWORK
POWER / NETWORK
POWER
NETWORK
POWER / NETWORK
POWER
NETWORK
POWER / NETWORK
POWER
NETWORK
POWER / NETWORK
POWER
NETWORK
POWER / NETWORK
POWER
NETWORK
PLEASE NOTE: The SP-1000 has two AC outlets
that are on the same circuit. Both outlets are either
On or OFF at the same time. The front side outlet
can accommodate transformer or “wall wart” types
of plugs, etc.
DQS-00009 REV. B

Summary of content (2 pages)