User Manual

INSTALLATION INSTRUCTIONS MD2-ZB
This device complies with part 15
of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device in
accordance with the specifications of Part 15 of FCC rules. These specifications are designed to
provide reasonable protection against such interference win a residential installation.
However, there is no guarantee that interference will not occur in a particular installation.
MD2-ZB
OPTIONS FOR MOUNTING & FRONT COVER FACEPLATE
Cover can be removed & painted to match color
of wall. The cover only can be painted. Do not
paint the sides, top or bottom of the unit or
Warranty will be voided.
www.panamax.com www.mybluebolt.com
www.panamax.com www.mybluebolt.com
1
Cover can be flipped around 180 degrees to
hide LEDs from front straight-on view if desired.
RF / ZigBee
®
ZigBee®/802.15.4 Radio
2.405-2.475 GHz, unlicensed ISM band
3dBm transmitter output
-99dBm receiver sensitivity
General
Weight__________ 0.7lb
Dimensions_______ 3.25 in. W X 1.625 in.
D X 5.25 in. H
Electrical Ratings
Line Voltage ______ 120 Vac, 60Hz
Current Rating _____ 12 A
Voltage Protection Rating (UL 1449 3rd Edition,
3,000A) _________ 400V L-N, 600V L-G,
500V N-G
Nominal Discharge Current
(UL1449 3rd Edition _ 3,000A
Electrical Measurements
RMS Voltage ______ 1% precision
RMS Current ______ 1% precision
Power___________ 2% precision
Cumulative Energy__ 2% precision
SPECIFICATIONS
Unit can be securely screwed into wall outlet
faceplate using either hole (2) indicated (screw
is included).
WARRANTY POLICIES
Product Warranty: Limited 3 Year Warranty
Connected Equipment Protection Policy:
Limited $100,000
Connected Equipment Policy
C US
AGENCY APPROVALS
CCSAUS Certified: UL1449 3rd Edition
(Type 3 SPD), CSA C22.2 No. 42
UL 1449 Voltage Protection Rating:
400V L-N, 600V L-G, 500V N-G
Cover of MD2-ZB can easily be removed by
pulling off cover at the two side indents (1).
2
OUTLET 1
Left side
Ground Pin Out
OUTLET 2
Right side.
Ground Pin
Down
POWER STATUS INDICATOR LIGHTS
Outlet 1
Network
Connection
Status
INDICATOR
LIGHTS
Outlet 2
Wiring Fault
PUSH BUTTONS
For Outlet’s Power ON/OFF
and Network Connection
REMOVABLE COVER
FACEPLATE
Finger Indent to
Pull Off Cover.
In accordance with FCC 15.21, changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
ZigBee is a registered trademark of ZigBee Alliance, Inc.
DIN-00019-B 11/12