Pamex Enkore Smart EKS-WR1N A Multi-Family Door Access Control Solution Hardware Installation Guide
Table of Contents Hardware Installation Wall Reader – Enkore Smart EKS-WR1N Features Hardware Specifications Front View Back View Wiring Pigtail Rated note Basic Door Installation Wiring Surface Mounting Mounting to single gang recessed outlet box Dimensions Installation Guide Enkore Smart EKS-WR1N Operation Modes 3 3 3 3 5 5 6 6 7 7 8 9 9 11
Hardware Installation Wall Reader – Enkore Smart EKS-WR1N Features ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● IP55 Weatherproof suitable for external use Advanced tamper detection Wi-Fi enabled access controller connected directly to existing routers Lock and unlock lockset remotely (Wi-Fi) MIFARE DESFire EV1/EV2 credential required (sold separately) High-Security authentication with 128-bit AES Encryption 6000+ cards/fobs and 10,000 activity logs memory capacity Alert email notification Access time control for both a
● ● Electrical life Min. 100,000 operations at 2A resister load Electrical life Min.
Front View Figure 1 : Enkore Smart EKS-WR1N Front Back View Figure 2: Enkore Smart EKS-WR1N Back
Wiring Pigtail Rated note Figure 3: Enkore Smart EKS-WR1N Wiring Pigtail Rated note Basic Door Installation Wiring Figure 4: Enkore Smart EKS-WR1N Basic Door Installation Wiring
Surface Mounting Figure 5 : Enkore Smart EKS-WR1N Surface Mounting Mounting to single gang recessed outlet box Figure 6 : Enkore Smart EKS-WR1N MOUNTING TO SINGLE GANG RECESSED OUTLET BOX
Dimensions Figure 7: Enkore Smart EKS-WR1N
Installation Guide Enkore Smart EKS-WR1N 1) Screw the back plate to lock base with three 4mm*12mm self-tapping screws. See the picture below. 2) Place the waterproof rubber on the back of the Wall Reader. See picture 1&2. 3) Before fastened Wall Reader, please ensure the waterproof rubber is installed.
Align the hole with the hook on the top of the back plate. See picture 3, Push down the Wall Reader. See picture 4. Tighten up the Wall Reader with a 4mm*8mm screw. See picture 5.
Operation Modes The Enkore Smart Door Reader EKS-WR1N can function on one of the three modes mentioned below. Card Mode Use NFC card to unlock. While the NFC card is being reading, Phone mode and Link mode will be temporarily disabled Phone Mode (Bluetooth) In this mode, you need to download a EnkoreSmart app and register an account. You can operate the lock after a successful pairing to the lock via the Bluetooth.
FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.