Packet Power™ Ethernet Gateway Version 3 Users Manual Version 1.
NOTES Read all instructions carefully prior to installation. No field-serviceable parts. Do not attempt to disassemble the product as potentially severe electrical shock may result. Installation and maintenance must be performed by qualified personnel. Follow basic safety precautions to reduce theLLC risk of electrical shock and damage Packet Power, to equipment. 233 Park Avenue, Suite 203 Store in a clean, dry location. Clean with a dry cloth.
REGULATORY INFORMATION This product has been certified to meet the following requirements: UL / ANSI standards 61010-1,Second Edition, Dated July 12, 2004 with revisions through and including October 28, 2008 CAN/CSA-C22.2 No. 61010-1, second edition, including Amendment 1, or a later version of the same standard incorporating the same level of testing requirements.
Packet Power™ Ethernet Gateway Version 3 Product Manual Overview The Ethernet Gateway version 3 is the central Gateway by which all Packet Power monitoring nodes (environmental and power) communicate. This guide is intended to provide a high level overview of how to commission a Gateway module. Refer to the support section of www.packetpower.com for additional support. Introduction to the Gateway Gateway Placement: Gateway placement is critical.
Packet Power™ Ethernet Gateway Version 3 Product Manual Device Setup Connect the Gateway to a router (using a standard network cable) with network access using the Ethernet port on the back of the Gateway. Connect the power supply provided or any 5 VDC source to the DC input of the Gateway. The Gateway can be powered using PoE (Power over Ethernet) using a splitter and 5VDC PoE source.
Packet Power™ Ethernet Gateway Version 3 Product Manual Menu Access and Navigation To access the menu for the Gateway, press and hold the selector button on the back of the device for three seconds. To navigate the menu, use short clicks of the selection button; to change a setting or advance into a menu item press and hold the button. The menu tree is shown in the table below.
Packet Power™ Ethernet Gateway Version 3 Product Manual To properly configure the IP address, the Gateway, Netmask and DNS server address must also be entered. To change these parameters use the same menu navigation style as described above. After the DNS Server address is set you will need to reboot to have implement your changes. Do this by pressing HOLD when “Reboot” is displayed. “Booting” will show on the display while the unit reboots and implements your changes.
Packet Power™ Ethernet Gateway Version 3 Product Manual Gateway Placement and Mounting Bracket The Gateway mounting bracket is designed to allow optimal placement of Gateway and Environmental Monitor modules away from metallic surfaces and optimize signal strength. It can be secured to mounting structures using bolts, screws or adhesive tabs provided. Bracket with Gateway Mounting Surface Dimensions; holes and cutouts are intended for use with cable ties for cable management.
Packet Power™ Ethernet Gateway Version 3 Product Manual Device Placement Never inside of a metal structure (exterior of the rack) Ideally with-in 30-100 feet of another Packet Power device (gateway or monitoring module) 2-4” (5-10 cm) away from a large metallic surface or mounted on a non-metallic platform (use the mounting bracket for optimal placement Higher is better; always try and locate the monitoring node at the highest point that allows an unobstructed path to another monitoring node or ga
Packet Power™ Ethernet Gateway Version 3 Product Manual Specifications Copyright 2014 © Packet Power, LLC.
Packet Power™ Ethernet Gateway Version 3 Product Manual Copyright 2014 © Packet Power, LLC.
