Installation Instructions

The manual of the item SW79777

1:Function:Steady- Flash -Off ,when operation the front light ,the function of the rear light is the

same .If the rear light didn’t received the signal from front light ,the front light will quick flash to

remind this situation .if the client just wish to use the front light ,press the button more than 3

seconds. if client wish to use the two light’s together ,press the light one time ,then the rear

light with battery will start to work .

2:Code processing: long press the front light button for 10 seconds to enter the code mode, at

this time, the rear light battery can be installed to the code

3:Both front and rear light have low battery indicator .

4:Front light : Lithium polymerbattery 3.7V ,1200MA .rear light:3V ,AAA*2

5:When charge the front light ,the green led will be on ,when finish charge ,the green led will be

off .the charging time is around 3 hours .

6:Long press the button for 60 seconds to enter the test mode, short press to switch the

frequency point/carrier, and long press 5 seconds to exit the test mode.The eighth pin of

receiver chip is connected to a ground button, long press 5 seconds to enter the test mode,

long press 3 seconds to enter the code mode, short press to switch the frequency point carrier.

Attention:

1:The rear light is under low power consumption standby mode ,if long time no use the

light ,pls take the battery out to aviod the weeping happen

2:Under the situation of turn off ,when restart the rear light , it will need around 2 seconds ,this

is normal situation .

3:Please take attention that changes or modification not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment.

PAGE 1
The manual of the item SW79777 1:Function:Steady- Flash -Off ,when operation the front light ,the function of the rear light is the same .If the rear light didn’t received the signal from front light ,the front light will quick flash to remind this situation .if the client just wish to use the front light ,press the button more than 3 seconds. if client wish to use the two light’s together ,press the light one time ,then the rear light with battery will start to work .
PAGE 2
FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.