User Manual

ManualsBrandsPAC ManualsCar & Vehicle ElectronicsDouble DIN Dash Kit & Interface harness for Select 2015-2017 Ford F150-F550 Trucks,black

Complete Radio Replacement with

Integrated Climate Control Retention for

select 2015-2017 Ford F150 and 2017 Ford Super Duty

RPK4-FD2201

PAC-audio.com

Pacific Accessory Corporation

Page 1

Rev. 073117

Introduction & Features

Important Notes

The RPK4-FD2201 is a complete radio replacement kit with integrated climate control retention for the 2015-2017 Ford

F-150 and 2017 Ford Super Duty equipped with the 4” screen. This kit utilizes the factory HVAC control knobs for a more

factory look and experience. This kit also includes all of the modules and cables needed to retain all of the important

features of the factory system such as: steering wheel mounted radio controls, factory reverse camera, AM/FM reception,

factory auxiliary input (if equipped) and the factory USB port (if equipped). With the addition of the VS41 (sold separately)

you can also add blind spot and front camera to the aftermarket radio.

1. We recommend that you read this manual thoroughly to familiarize yourself with the entire process before beginning installation.

2. Transfer of the factory HVAC knobs, circuit boards, and auxiliary button panel is required. Professional installation is

recommended.

3. WARNING! Failure to install the supplied ribbon cables properly will result in LOSS / INTERMITTENT operation of CLIMATE

CONTROLS! Follow instructions carefully!

4. Only compatible in vehicles equipped with the 4” screen.

5. Does not retain SYNC.

6. Does not retain auxiliary input jack in 2015 vehicles equipped with SYNC.

7. Once the radio is removed, the chimes will play through the small dash speaker and not the

cabin speakers.

8. Use of improper length screws during kit re-assembly can result in damage to this product.

Please pay special attention to Part Three: Step 6, and DO NOT use the 22mm long screws.

Damage will occur!! 22mm long screws are only used in Part Three: Step 9.

Components

1. Dash Panel with HVAC

Control

2. Middle Circuit Board Housing

3. Bottom Circuit Board Housing

4. Pocket (For single DIN

applications)

5. (x2) Radio Brackets (left and

right)

6. AM / FM Antenna Adapter

7. Reverse Camera Retention

Harness (used only when

equipped with factory reverse

camera)

8. (x2) Ribbon Cables

9. RP4.2 Interface Harness

10. (x8) 6mm Screws

11. (x9) Radio Mounting Screws

12. USB Retention Cable (if

equipped)

13. RP4.2 Interface

Tools needed for installation : 7mm socket, 10mm socket, ratchet, T10 torx screwdriver, small athead screwdriver, plastic panel

removal tool .

1:1

22mm

6mm

16mm

Summary of content (14 pages)

PAGE 1
RPK4-FD2201 Complete Radio Replacement with Integrated Climate Control Retention for select 2015-2017 Ford F150 and 2017 Ford Super Duty Introduction & Features The RPK4-FD2201 is a complete radio replacement kit with integrated climate control retention for the 2015-2017 Ford F-150 and 2017 Ford Super Duty equipped with the 4” screen. This kit utilizes the factory HVAC control knobs for a more factory look and experience.
PAGE 2
Complete Radio Replacement with Integrated Climate Control Retention for select 2015-2017 Ford F150 and 2017 Ford Super Duty RPK4-FD2201 Installation Part One: Disassembly of Factory Dash 1. Remove front dash panel from vehicle by prying up on the top dash panel with a plastic pry tool, then removing the two 7mm screws located under the top dash panel. 2. Remove the factory screen, SYNC module (if equipped), and Audio Control Module (ACM) using a 7mm socket. These parts are no longer needed.
PAGE 3
Complete Radio Replacement with Integrated Climate Control Retention for select 2015-2017 Ford F150 and 2017 Ford Super Duty RPK4-FD2201 Part Two: Disassembly of Factory Dash Panel 1. Remove hazard and traction control buttons from factory dash panel by pushing in on the release tabs. Set aside for later use. 4. Make sure that the white line on the temperature control knob is centered at the top. Remove back of factory dash panel by releasing the locking tabs on each side. 2.
PAGE 4
Complete Radio Replacement with Integrated Climate Control Retention for select 2015-2017 Ford F150 and 2017 Ford Super Duty RPK4-FD2201 Disassembly of Factory Dash Panel (cont.) 7. Remove (6) T10 16mm screws from bottom circuit board. Set aside for later use. 8. Remove bottom circuit board and set aside for later use. 9. Remove temperature control and fan speed knobs. Set aside for later use. 10. Remove HVAC buttons (make sure the rubber button pad comes with it). Set aside for later use. 11.
PAGE 5
Complete Radio Replacement with Integrated Climate Control Retention for select 2015-2017 Ford F150 and 2017 Ford Super Duty RPK4-FD2201 Disassembly of Factory Dash Panel (cont.) This is the end of part two. Please continue to the next section to begin part three. 13. Remove the auxiliary button pad (make sure the rubber button pad comes with it) and set aside for later use. 14.
PAGE 6
Complete Radio Replacement with Integrated Climate Control Retention for select 2015-2017 Ford F150 and 2017 Ford Super Duty RPK4-FD2201 Assembly of Aftermarket Dash Kit (cont.) 4. Install the temperature and fan speed knobs as shown. Please make sure that the white line on the temperature control knob is centered at the top. 7. Install the black plastic gear as shown. Make sure the alignment mark on the gear is pointing at the gear attached to the temperature control knob. 5.
PAGE 7
Complete Radio Replacement with Integrated Climate Control Retention for select 2015-2017 Ford F150 and 2017 Ford Super Duty RPK4-FD2201 Assembly of Aftermarket Dash Kit (cont.) 10. Connect the (2) supplied ribbon cables to the bottom circuit board as shown. Make sure that the copper contacts on the ribbon cables are facing towards you. Once the cables are seated in the connector, lock them in place by pushing down on the locking tabs. 13.
PAGE 8
Complete Radio Replacement with Integrated Climate Control Retention for select 2015-2017 Ford F150 and 2017 Ford Super Duty RPK4-FD2201 Assembly of Aftermarket Dash Kit (cont.) This is the end of part three. Please continue to the next section to begin part four. 16. Install the middle circuit board housing as shown. Make sure that the top of the housing clears the auxiliary button pad during placement. 17. Using (4) of the supplied 6mm T10 screws, secure the housing to the panel as shown.
PAGE 9
Complete Radio Replacement with Integrated Climate Control Retention for select 2015-2017 Ford F150 and 2017 Ford Super Duty RPK4-FD2201 DIP Switches and Wiring Connections Set DIP switches that match your radio to the ON position Set all other DIP switches to the OFF position 1 2 3 4 DIP ON Alpine JVC Kenwood Clarion Pioneer/Other Sony Fusion 1 2 1&2 3 1, 2, & 3 4 1&4 Other = Advent, BOYO, Dual, Lightning Audio, Rockford Fosgate, Visteon 1.
PAGE 10
Complete Radio Replacement with Integrated Climate Control Retention for select 2015-2017 Ford F150 and 2017 Ford Super Duty RPK4-FD2201 VS41 Wiring These Connections are not used in this application PLEASE NOTE: Revision 1.0.6.1 of the VS41 is required for this application. If you are adding a front camera and two blind spot cameras, or any combination of the three, to the aftermarket radio, a VS41 is needed (sold separately).
PAGE 11
Complete Radio Replacement with Integrated Climate Control Retention for select 2015-2017 Ford F150 and 2017 Ford Super Duty RPK4-FD2201 Steering Wheel Controls (Cont.) Optional Steering Wheel Control Programming If you wish to re-assign the SWC functions, utilize short press long press dual command functionality, or assign the programmable 12v output to a SWC button, the interface must be programmed in the specific order shown in the chart below.
PAGE 12
RPK4-FD2201 Complete Radio Replacement with Integrated Climate Control Retention for select 2015-2017 Ford F150 and 2017 Ford Super Duty RadioPRO App Use of the RadioPRO App in Ford allows you to do the following: • Configure User Interface Options such as: • Red / White wire output behavior • Aftermarket radio parking brake sequencing • Update Product Firmware • Read Firmware / Hardware Versions • Access Product User Manuals Programmable Red/White Wire The Red / White wire can be programmed to do a puls
PAGE 13
RPK4-FD2201 Complete Radio Replacement with Integrated Climate Control Retention for select 2015-2017 Ford F150 and 2017 Ford Super Duty RadioPRO App (cont.) Pioneer Parking Brake - Turning this feature on will make the parking brake output produce the necessary sequencing for settings menu access. This sequencing is based on the actual parking brake, meaning to produce this sequence you have to engage the parking brake in the vehicle.
PAGE 14
Complete Radio Replacement with Integrated Climate Control Retention for select 2015-2017 Ford F150 and 2017 Ford Super Duty RPK4-FD2201 Testing and Verification 1. 2. 3. 4. 5. Turn the ignition on. The LED on the interface will turn on and the +12v accessory wire will turn on. Turn on the radio and check balance and fade. Verify that all SWC are functioning properly. Verify that the programmable 12v+ output is functioning as intended (if connected). Verify that all HVAC controls are functioning properly.