User's Manual

International Ltd

1 Park Gate Close, Bredbury,

Stockport, SK6 2SZ, England

Tel: +44 (0) 161 406 3400

Fax: +44 (0) 161 430 8658

INTERNATIONAL

Data Sheet

November 1999

PAC 2200 Series and PAC 2100 Series

Programming Panel Instructions

Reader 16 character display

48 Key Keypad





1.5m Flying Lead

Description

The PAC 2100 Series and PAC 2200 Series of door controllers are programmed from a panel

attached to the front of the controller. This panel consists of a 48 key keypad, a 16 character

display and a KeyPAC proximity key administration reader. This front panel is commonly fitted

when the controller is a Master controller (System Types 0, 1 and 2). However when used as a

Slave controller (System Type 3) then, apart from initial programming, the panel is unnecessary.

PAGE 1
Data Sheet INTERNATIONAL November 1999 PAC 2200 Series and PAC 2100 Series Programming Panel Instructions 1.5m Flying Lead Reader 16 character display 48 Key Keypad Description The PAC 2100 Series and PAC 2200 Series of door controllers are programmed from a panel attached to the front of the controller. This panel consists of a 48 key keypad, a 16 character display and a KeyPAC proximity key administration reader.
PAGE 2
PAC 2200 Series and PAC 2100 Series Programming Panel 170XX Ver 1.0 How to Use the Programming Panel Note: You should follow the instructions provided in the manuals for the controller being used (17113 PAC 2100/1100 Installation Manual and 17112 PAC 2100/1100 User Manual or 17263 PAC 2200 Series Controllers Installation Manual and 17267 PAC 2200 Series Controllers User Manual) for full details on programming these door controllers.
PAGE 3
PAC 2200 Series and PAC 2100 Series Programming Panel 170XX Ver 1.0 To use the Programming Panel: 1. Remove power from the door controller, not forgetting to disconnect any batteries as well. 2. Connect the flying lead from the panel as follows: Into the socket at the top left of the door controller circuit board, just above the orange power supply connector, for the PAC 2100 Series Controllers (Figure 1). The connector is keyed and will only fit in the correct orientation.