User's Manual

INTERNATIONAL

Data Sheet

October 1999 17XXX Ver 1.0

20447-2 KeyPAC Desktop Reader

Installation Instructions

Description

The KeyPAC PC Desktop Reader is an accessory for use with a PAC Adminstration interface

unit. This system is used for direct PC to controller communications (fig. 1).

Note: This Desktop Reader will read KeyPAC ID-devices including ISO thickness ID cards. It

will not read the earlier PAC ID devices. Always specify KeyPAC when you buy ID

devices.

Note: It is unlikely that you will need an Interface Kit at a PC that already has a KeyPAC CNC

attached. CNCs have front panel readers, which can also be used for administration.

WARNING: The Interface Unit contains mains voltages. This procedure should only be carried

out by a suitably qualified and experienced person. If you have any doubts as to

your suitability contact PAC for advice. Failure to do so may result in injury or death

by electric shock.

WARNING: If, at any time, the interface kit or its wiring appear damaged then immediately

disconnect it from the mains and contact PAC for advice. Failure to do so can result

in electric shock and/or further damage to equipment.

PAGE 1
INTERNATIONAL Data Sheet October 1999 17XXX Ver 1.0 20447-2 KeyPAC Desktop Reader Installation Instructions Description The KeyPAC PC Desktop Reader is an accessory for use with a PAC Adminstration interface unit. This system is used for direct PC to controller communications (fig. 1). Note: This Desktop Reader will read KeyPAC ID-devices including ISO thickness ID cards. It will not read the earlier PAC ID devices. Always specify KeyPAC when you buy ID devices.
PAGE 2
KeyPAC 17 Ver 1.0 Installation Opening the Interface Unit WARNING: This Interface Unit contains mains voltages. Before opening ensure that it is disconnected from the mains. Failure to do so can result in injury or death by electric shock. Make sure that the Interface Unit is not connected to the mains then remove the lid by removing the 4 screws recessed in the base.
PAGE 3
KeyPAC 17 Ver 1.0 Specification Dimensions 5.12in x 3.54in x 1.25in Voltage 10.5v DC to 20v DC (Supplied by Administration Interface Unit) Current Idle: 10-20mA Reading: 10-20mA Operating: -10°C to +55°C (14°F to 130°F) Storage: -30°C to +80°C (-20°F to 175°F) Humidity Operating: 0-90% RH at 30°C ±2°C (85°F±5°F) for 24 hours Reading Range 0-2 inches Lead Length 56 inches Temperature This device complies with part 15 of the FCC rules.