P.G. TM0026AE electronics OPERATOR'S MANUAL PCS REPEATER MODEL R231 P/N 001-0231-001 MARCH 2002 RESTRICTION ON DISCLOSURE OF DATA This document contains information proprietary to P.G. Electronics and any disclosure or use of this information or any reproduction of this document for other than the specific purpose for which it is intended is expressly prohibited except as P.G. Electronics may otherwise agree in writing.
P.G. TM0026AE GUARANTEE This unit is guaranteed for a period of one year from the date of shipment against failure due to defective parts or improper assembly. This guarantee is limited to replacement of defective material and does not cover damages or other costs resulting from the use of this material whether used correctly or otherwise.
P.G. TM0026AE TABLE OF CONTENTS Page Paragraph SECTION 1. GENERAL INFORMATION 1.1 1.1.1 1.1.2 1.1.3 1.1.4 1.2 INTRODUCTION Scope of Manual Purpose of Equipment Physical Description Electrical Description TECHNICAL SUMMARY 1-1 1-2 1-3 1-3 1-3 1-3 SECTION 2. INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS 2.1 2.2 2.
P.G.
P.G. TM0026AE SECTION 1. GENERAL INFORMATION 1.1 INTRODUCTION 1.1.1 Scope of Manual. - This manual is intended to familiarize personnel installing the R231 PCS Repeater with all pertinent aspects of the amplifier. Included in this manual are a brief physical description, a technical summary, installation and operating data. 1.1.2 Purpose of Equipment. - The R231 Repeater is used as a drop-in booster for PCS signals.
P.G. TM0026AE TABLE 1-1. Performance Characteristics and Salient Features of the R231 PCS Repeater Parameter Specification 1. Input Power: 15 to 32 VDC @ 500 mA Max. 2. Frequency Range: - Base Receive (Uplink) - Base Transmit (Downlink) 1851MHz to 1909 MHz 1931 MHz to 1989 MHz 3. Rated RF Input: -32 dBm Maximum (single channel) Note: The following specifications apply in both directions 4. Gain: 43 dB ±3 dB 5. Impedance (Input and Output): 50 Ohms 6. VSWR: 2:1 Typical 7.
P.G. TM0026AE NOTE IMPORTANT RATING INFORMATION Manufacturer’s rated output power of this equipment if for single carrier operation. For situations when multiple carrier signals are present, the rating would have to be reduced as per Table 1-2, especially where the output signal is re-radiated and can cause interference to adjacent band users. This output power reduction is to be achieved by reduction of input power.
P.G. TM0026AE SECTION 2. INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS 2.1 UNPACKING AND INSPECTION The following checks are recommended after receipt of the equipment from shipping agent: 1. Check for any external damage that could have occurred in transit. If damage is found, report to the shipping agent and to the supplier immediately. 2. Check that all items on the packing slip are present. If any are missing, report to the supplier immediately. 2.
P.G. TM0026AE CONNECTOR REFERENCE J1 SIGNAL DESCRIPTION BASE RECEIVE INPUT (UPLINK) BASE TRANSMIT OUTPUT (DOWNLINK) J2 TYPE N N BASE TRANSMIT INPUT (DOWNLINK) BASE RECEIVE OUTPUT (UPLINK) DC IN 15-32 VDC INPUT Figure 2-1.