J801X Technical Specs

ManualsBrandsOxbox ManualsFurnacesJ801X - 100k BTU - Ultra Low NOx Gas Furnace - 80% AFUE

• Ultra-low emissions: 65% less NOx than standard

furnaces.

• 100% ﬁred and tested: All units and each component

are tested on the manufacturing line.

• Low Boy Height: Easy to apply in low ceiling applications,

works well with taller high SEER coils, easier to handle

and install.

• Tubular primary heat exchanger: Heavy gauge

aluminized steel heat exchanger assures a long life.

• 30 second blower delay at start-up: Assures a warm

duct temperature at furnace start-up. Adjustable blower

off settings (60, 90, 120 and 180 seconds).

• 30 second post purge: Increases life of heat exchanger.

• Hot surface igniter: Innovative application of a silicon

nitride igniter.

• Color coded wire harness: Designed to fit the

components, all with quick-connect ﬁttings for ease of

service and replacement.

• High static blowers: All models equipped with high static

blowers.

• 60 second cooling cycle blower-off delay (TDR):

increases cooling performance.

• Flexible category I venting system: May be vented with

dedicated venting system or common vented with other

category one appliances.

• High efﬁciency blower kits: Maximize efﬁciencies and

provide better temperature control, humidity control and

air distribution.

• Multi-speed direct drive blower: Energy-efﬁcient,

brushless DC (ECM). Designed to give a wide range of

cooling capacities. Switches on PCB, provide ultra easy

motor speed selection.

• Diagnostic lights for easy troubleshooting without

counting ﬂashes: Dedicated light for ﬂame signal strength

and 2 lights in combination to indicate all other fault codes

with easy to recognize states without counting ﬂashes.

• Integrated control board: Incorporates connections

for electronic air cleaner and humidiﬁer. Ergonomically

located for ease of service.

• Two piece door design: Enhances furnace appearance

and uses captured screws to prevent loosing door screws.

• Furnace Air Leakage: These furnaces comply with

Energy Star cabinet air leakage requirement of less than

or equal to 2%. Keep the conditioned air ﬂowing to where

it's needed.

Induced Draft - 80+ AFUE, Ultra-Low NOx

Input 55,000 - 100,000 Btuh

J801X(*)L Series

Single Stage Upﬂow/Horizontal

Gas Furnaces

The gas furnace may be installed free standing in a utility

room, basement, or enclosed in an alcove or closet. The

rounded corner jacket provides a pleasing “appliance

appearance.” Design certiﬁed by CSA for application in

the United States.

FEATURES and BENEFITS

TECHNICAL

SPECIFICATIONS

This furnace series is approved and certiﬁed by the

SCAQMD and the SJVAPC Districts in the state of

California with NOx levels below 14 ng/J when operating

on natural gas.

Summary of content (8 pages)

PAGE 1
TECHNICAL SPECIFICATIONS J801X(*)L Series Single Stage Upflow/Horizontal Gas Furnaces Induced Draft - 80+ AFUE, Ultra-Low NOx Input 55,000 - 100,000 Btuh The gas furnace may be installed free standing in a utility room, basement, or enclosed in an alcove or closet. The rounded corner jacket provides a pleasing “appliance appearance.” Design certified by CSA for application in the United States.
PAGE 2
PAGE 3
GAS FURNACE DIMENSIONS TOP VIEW ULTRA-LOW NOX UPFLOW/HORIZONTAL FURNACE BOTTOM VIEW C D Front Brace DIM. -B- DIM. -C- DIM. -D- 055U 14 1/4 10 3/4 12 5/8 12 7/8 070U 17 1/2 11 3/4 15 7/8 16 1/8 100U 21 14 19 3/8 19 7/8 FL 23 AN GE S 19 Bottom Panel NOTE: Dimensions shown in Inches. 5/8 18 5/8 DIM.
PAGE 4
MODEL IDENTIFICATION CODE J 80 1 X 072 B U 3 S Brand Model Family 80 = 80% AFUE 90 = 90% AFUE 95 = 95% AFUE 96 = 96% AFUE NOx Digit S = Standard T = 40 Ng/J NOx L = 14 Ng/J NOx Gas Valve Stages 1 = 1 Stage Gas Valve 2 = 2 Stage Gas Valve M = Modulating Stage Gas Valve Blower Type P = PSC Motor E = ECM Motor X = X13 Constant Torque Motor V = Variable Speed Motor (Constant CFM) Nominal Cooling Airflow 3 = 3 Tons 4 = 4 Tons 5 = 5 Tons V = Variable Input BTUH 045 = 45,000 054 = 54,000 072 = 72,000
PAGE 5
AIRFLOW DATA HEATING AIRFLOW (CFM) & TEMPERATURE RISE (°F) MODEL NAME/ HEATING INPUT RETURN AIR VIA: MOTOR SPEED TAP EXTERNAL STATIC PRESSURE (IN. W.C.) 0.1 0.2 0.3 0.4 0.
PAGE 6
AIRFLOW DATA HEATING AIRFLOW (CFM) & TEMPERATURE RISE (°F) MODEL NAME/ HEATING INPUT RETURN AIR VIA: MOTOR SPEED TAP EXTERNAL STATIC PRESSURE (IN. W.C.) 0.1 0.2 0.3 0.4 0.
PAGE 7
AIRFLOW DATA HEATING AIRFLOW (CFM) & TEMPERATURE RISE (°F) MODEL NAME/ HEATING INPUT RETURN AIR VIA: MOTOR SPEED TAP EXTERNAL STATIC PRESSURE (IN. W.C.) 0.1 CFM 0.2 RISE CFM 0.3 RISE 0.4 CFM RISE 50 0.
PAGE 8
GENERAL TERMS OF LIMITED WARRANTY Trane Technologies will furnish a replacement for any part of this product which fails in normal use and service within the terms and conditions of the warranty. For complete details of the Limited Warranty, including applicable terms and conditions, see your local installer or contact the Trane Technologies warranty department for a copy. Before purchasing this appliance, read important energy cost and efficiency information available from your retailer.