User's Guide

ManualsBrandsOwl Home ManualsElectronicsOwl Wired

User Guide for Owl Wired

A. Introduction

Owl Wired replaces your smoke detector with an all-in-one smart home security system

that detects Smoke, Carbon Monoxide, Motion, Sound, Temperature & Humidity.

B. Features

a. Photoelectric Smoke detection

b. Electrochemical Carbon Monoxide detection

c. Microwave RADAR Motion detection

d. Sound level detection

e. Temperature & Humidity detection

f. Wi-Fi connected with Apple HomeKit support

g. Backup Lithium-ion battery that can power the device during power outages

h. 85dB loud buzzer and a multicolour LED ring

i. 120-240V AC and USB-C DC power support

j. Over the air software updates

k. Interconnects with most traditional smoke detectors(available late 2021)

C. Appearance

Summary of content (7 pages)

PAGE 1
User Guide for Owl Wired A. Introduction Owl Wired replaces your smoke detector with an all-in-one smart home security system that detects Smoke, Carbon Monoxide, Motion, Sound, Temperature & Humidity. B. Features a. Photoelectric Smoke detection b. Electrochemical Carbon Monoxide detection c. Microwave RADAR Motion detection d. Sound level detection e. Temperature & Humidity detection f. Wi-Fi connected with Apple HomeKit support g.
PAGE 2
D. Installation a. Remove existing Mounting Bracket from the ceiling if needed b. Install provided Mounting Bracket in the box using provided 2 screws c. Connect the 3 wires with the power connector accordingly and put on the screw cap on each wire connection Black - Hot/Line White - Neutral Orange - Interconnect d. Insert the Power Connector on back of the device e. Power on the device by turning on the switch in the back f.
PAGE 3
E. Instructions a. How to setup Owl Wired i. Install Owl Home app from testflight: link here ii. Open Owl Home app iii. iv. Sign up or Login if you have created an account Tap on Add icon on the top right v. Tap on Scan Now Button vi.
PAGE 4
vii. Select your Wi-Fi details and save b. Button Silence Pressing the button when an alarm is on silences the alarm. Reset Pressing and holding the button for 15 seconds causes the device to reset. c.
PAGE 5
d. e. f. g. h. Under normal standby circumstances, the white light flashes once every 30 seconds. Low battery warning When the battery capacity is low, the orange light flashes every 10 seconds and shows battery low in the mobile app Alarm On When the alarm detects more than 300ppm of carbon monoxide gas concentration, the alarm will trigger within 3 minutes. During this time, the buzzer will make the sound “di” 4 times every 5 seconds and red light will also flash.
PAGE 6
F. Technical Parameters a. 802.1n (2.4GHz), upto150Mbps Wi-Fi b. Bluetooth 4.2 c. 1000mAh 3.7V internal Lithium battery d. 120V - 240V AC Power Supply e. 6 Multi-colour LED ring f. Loud Buzzer with 89dB sound pressure at 3m g. Sensors: i. Electrochemical CO sensor Sensitivity: 0 - 9,999ppm ii. Photoelectric smoke sensor Sensitivity: 0.1db/m - 9.9db/m iii. Microwave RADAR motion sensor Sensitivity: 6m radius and detects beyond walls iv. Microphone Sensitivity: -26dB ±3dB @ 94dB SPL v.
PAGE 7
Warning 6tatement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.