Technical Specs

ManualsBrandsOwasys Advanced Wireless Devices ManualsElectronicsOWA450

DESI-BOK100_9103-en-C.doc

This equipment conforms to the Radio Equipment Directive (RED) 2014/53/EU, covering requirements included in EMC directive 2014/30/UE,

and Low Voltage Directive 2014/35/UE as well as other requirements as those from ROHS Directive 2011/65/UE. Complete Declaration of

Conformity at Owasys web site:

http://owasys.com/bundles/owasysweb/docs/products/owa450/owa450.DoC.en.pdf

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may cause undesired operation.

DISPOSAL OF OLD ELECTRICAL & ELECTRONIC EQUIPMENT (APPLICABLE IN THE EUROPEAN UNION AND OTHER EUROPEAN

COUNTRIES WITH SEPARATE COLLECTION SYSTEMS).

This product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of

electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help preventing potential negative consequences

for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The recycling of

materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local

council, your waste disposal service or the distributor where you purchased the product.

Dispose of used batteries according to the instructions in section 3.10

1. owa450 kit content

▪ owa450 unit

2. Technical specifications summary

Item

Specification

Power Supply

9 to 48 Vdc (minimum 1.5A)

Operating Temperature range

-40 ºC to +85 ºC

Safety Purposes Temperature range without Li-ion battery

-40 ºC to +70ºC

Safety Purposes Temperature range with Li-ion battery

-40 ºC to +60 ºC

Discharge internally limited from -20 ºC to +60ºC

Charge internally limited from 0ºC to 45ºC

Storage Temperature

-40ºC to +85 ºC

3. Safety and other precautions

3.1. General

IMPORTANT: FOR THE EFFICIENCY AND SAFE OPERATION OF YOUR owa450 MODULE READ THIS INFORMATION BEFORE

USE!

Care must be taken when handling the unit. Only staff authorized by Owasys can dismantle the product. If the product is dismantled by

non-authorized people and/or ESD precautions are not taken the warranty is not valid.

Do not push objects into connectors of your device. Doing so can cause fire or electric shock by short-circuiting.

If the product is subject to severe conditions beyond the limits specified in the Technical Specifications, the product could be damaged.

Keep the device away from radiators and heat sources. The device may become hot during normal operation, so switch it off and wait for

a while before handling it.

Do not clean the device when powered up. Clean it with a soft cloth. Do not use liquid or aerosol cleaners, which may contain flammable

substances.

Use only approved batteries to avoid the risk of explosion. The use of an incorrect type of battery may cause an explosion.

3.2. owa450 connections

An external fuse should be included in the positive Vin supply with a rating of 2A (to protect the cables and input circuitry in case of a

faulty condition if the external power supply has not short circuit protection below 3A).

Summary of content (7 pages)

PAGE 1
This equipment conforms to the Radio Equipment Directive (RED) 2014/53/EU, covering requirements included in EMC directive 2014/30/UE, and Low Voltage Directive 2014/35/UE as well as other requirements as those from ROHS Directive 2011/65/UE. Complete Declaration of Conformity at Owasys web site: http://owasys.com/bundles/owasysweb/docs/products/owa450/owa450.DoC.en.pdf This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1.
PAGE 2
The highest internal voltage applied to the owa450 unit can be 48Vdc and complies with Low Voltage European Directive. The power supply can be made with a battery or continuous voltage supply with reinforced isolation. Before you connect the device to an electrical outlet, check the voltage and current rating to ensure that the required ones match the available power source. Exceeding the specified input range may cause unexpected operation and/or irreversible damage to owa450.
PAGE 3
.9. Handling the device Observe the following safe-handling guidelines to prevent damage to owa450: 3.10. • When setting up the device for work, place it on a level surface. • Protect the device from environmental hazards such as extreme temperatures and overexposure to sunlight. • When you move your device between environments with very different temperature and/or humidity ranges, condensation may form on or within the device.
PAGE 4
Class 3 (+24dBm +1/-3dB) for UMTS AWS, WCDMA FDD BdIV Class 3 (+24dBm +1/-3dB) for UMTS 1800, WCDMA FDD BdIX Class 3 (+24dBm +1/-3dB) for UMTS 900, WCDMA FDD BdVIII Class 3 (+24dBm +1/-3dB) for UMTS 850, WCDMA FDD BdV Class 3 (+24dBm +1/-3dB) for UMTS 800, WCDMA FDD BdVI Class 3 (+23dBm ±2dB) for LTE 700, LTE FDD Bd12 Class 3 (+23dBm ±2dB) for LTE 700, LTE FDD Bd28 Class 3 (+23dBm ±2dB) for LTE 800, LTE FDD Bd18 Class 3 (+23dBm ±2dB) for LTE 800, LTE FDD Bd19 Class 3 (+23dBm ±2dB) for LTE 800, L
PAGE 5
According to limitations established by the radio-modules Grants, antenna(s) gain should also be limited. For cellular antenna, in mobile and fixed operating configurations the antenna gain, including cable loss, must not exceed 2 dBi at 700 MHz, 5.15 dBi at 850 MHz, 2.15 dBi at 1700 MHz and 1900 MHz and 4.2 dBi at 2600 MHz for satisfying RF exposure compliance.
PAGE 6
5.3. 5.4. Connecting the cables ▪ Disconnect the power from the equipment whenever you manipulate it. ▪ Allow sufficient cabling to enable the removal of the equipment. ▪ Place a 2A fuse in the Vin positive cable. ▪ Ensure cables are not damaged or rubbing against sharp objects. ▪ The antennas should have an unobstructed view. GPS should have unobstructed view of the sky. Antennas should not be shielded from satellite signals by metal objects or other impenetrable materials.
PAGE 7
5.5. owa450 Front View Interfaces availability will depend on chosen model. See the most complete version below. * Connectors depend on product variant * M12 Connector is an alternative to RJ45. 5.6. owa450 Rear View Interfaces availability will depend on chosen model. See the most complete version below. * Connectors depend on product variant 6. SW Licenses This product includes SW under GNU/GPL Software licenses along with SW covered by owasys proprietary SW license.