User's Manual

ManualsBrandsOvisLink ManualsElectronicsFE0199-NIC-1

- 1 -

Introduction

Preface

Thank you for purchasing our product! This guide is designed for the experienced network

installer. It contains information about installation and configure the 32-bit high

performance Fast Ethernet PCI Local Bus adapter. It can be used with IBM PC/AT and

compatibles with PCI local-bus master slot.

The LFE-8139ATX network interface card (NIC) provides a network connection with the

Remote Wake-Up connector installed, it operates only in PCs with the Remote-Wake-Up

connector attached to the PC motherboard.

This NIC operates at 100Mbps or 10Mbps automatically, depending on the speed of the

connected hub.

Summary of content (10 pages)

PAGE 1
Introduction Preface T hank you for purchasing our product! This guide is designed for the experienced network installer. It contains information about installation and configure the 32-bit high performance Fast Ethernet PCI Local Bus adapter. It can be used with IBM PC/AT and compatibles with PCI local-bus master slot.
PAGE 2
Introduction Peripheral Component Interconnect (PCI) Bus Overview The Peripheral Component Interconnect (PCI) local bus is a high performance, 32- or 64-bit bus that dramatically increases the speed of I/O bound peripherals by directly connecting these devices to the CPU local bus. It is intended to use as an interconnected mechanism among highly integrated peripheral controller components, peripheral add-on cards, and processor/cache/memory subsystem.
PAGE 3
Introduction -3-
PAGE 4
Introduction The processor/cache/memory subsystem connects the PCI local bus through a PCI bridge. This bridge supports a low latency path through the processor, and may directly access PCI devices mapped anywhere in the memory or I/O address spaces. It also provides a high bandwidth path that allows PCI masters to directly access the main memory. The bridge may optionally include functions as data buffering/posting and PCI central functions.
PAGE 5
Introduction Product Description - What‘s is a LFE-8129ATX Network Adapter ? The LFE-8139ATX is a 32-bit PCI Fast Ethernet adapter equipped. It is designed for use on computers that are equipped with PCI bus slots. The adapter runs in the bus master mode and directly sending/receiving Ethernet packets to /from memory. The bus master device is a more intelligent device that can conduct processing independently of the bus or other devices.
PAGE 6
Introduction The following figure shows the board layout of the LFE-8139ATX network interface card : LED RJ45 Figure : 1-1 The LFE-8139ATX Network Interface Card -6-
PAGE 7
Introduction Remote Wake-up Support The LFE-8139ATX network interface card (NIC) provides a Remote Wake-Up feature that, combined with other remote control capabilities, gives technicians and ability to turn machines on remotely and automatically during off hours, to perform maintenance activities. The system can be automatically transitioned from a sleep state to a fully powered state over the network. Once the system is awake, it can be directed to run utilities and then return to sleep mode.
PAGE 8
Introduction that exist in the device on the other end of the wire, the Link Partner, and advertises its own abilities to automatically configure the highest performance mode of interoperation.
PAGE 9
Introduction ♦ Allow remote wake-up(Magic packet and Microsoft wake-up frame) ♦ Plug and Play: Simply insert the card into a PC and it will automatically be configuration by the PC BIOS ♦ Supports full-duplex operations, thus doubling the network speed up to 20Mbps on 10BASE-T Ethernet or 200Mbps on 100BASE-TX Fast Ethernet when setting in fullduplex mode ♦ Four LEDs indicators to report network status ♦ Single RJ-45 connector with Auto-sense of cable type of 10 or 100Mpbs network operation ♦ Support PCI c
PAGE 10
Introduction Package Contents Before you proceed further, please check and see do you have all the necessary materials from the shipping package and make sure nothing is missing. The complete package should include : one (1) LFE-8139ATX Network Interface Card (NIC) two (2) LFE-8139ATX NIC driver diskette one (1) Remote Wake-Up cable one (1) User's Manual If any of these items is damaged or missing, please contact your authorized network supplier.