Use and Care Manual

C. W
C
asher (6)
E. Nut (2)
F. Hex Wrench (1)
G. Open End Wrench (1)
D. Plastic
Washer (4)
Hardware Included:
1 2
Care Instructions:
Wicker Cleaning/Care:
Remove cushions, bolsters, and throw pillows, and stack on a clean
and dry surface. Use a mild soap and water to clean. Apply this
solution directly to heavily soiled areas. Wipe the entire furniture
surface with a damp rag or sponge. Rinse thoroughly with clean
water. Dry thoroughly before installing cushions.
WARNING:
CONTAINS SMALL PARTS, SHARP POINTS AND EDGES.
DO NOT CLIMB, LEAN, SIT, STAND OR PULL ON UNIT FOR SUPPORT.
ADULT ASSEMBLY REQUIRED.
!
IMPORTANT:
Retain these instructions
for future reference.
Periodically check all connections on your to
make sure they are tight and secure.
Install cushions (not shown). Your chair is
ready for use.
Operating Tips:
To recline the chair, simply lean back with
moderate pressure on the chair back.
The recliner will recline and the footrest
will extend. If you would like the chair to
recline to a flat position, apply pressure
on the chair back while reclining, and it
will recline to a flat position.
A. Short Bolt (2) B. Long Bolt (2)
Attach the back to the seat with Long Bolts (B) on upper holes and Short Bolts
(A) on lower holes, Washers (C) and Plastic Washers (D). Fasten Short Bolts
(A) with Nuts (E) and tighten all Bolts using Hex Wrench (F) and Open End
Wrench (G).
chair
IMPORTANT NOTE: During assembly, turn chair top upside down on carpet or padded surface to
protect the finish.
arm
back
B
A
C
C
E
D
D
arm
back
ASSEMBLY INSTRUCTION