Interactive Riser UIT421C-C01 User and Installation Guide
Table of Contents Package Contents Page 3 Interactive Riser Contents Package Contents 3 Installing the Mini Risers 5 Installation Instructions 6 Rear View 7 Updating the Joplin 8 Updating the Home 10 Setting the Default Volume on the Joplin and Home 11 Updating the System Software and System Reset 12 Functionality Test 14 Mini Riser x2 PSU with AC cable Butterfly Nut x2 Mini Riser Screw x4 Under Plate Suction Cup M5 Rod x2
Package Contents Page 4 Joplin Home Joplin Cable Home Cable Installing the Mini Risers Page 5 Step 1. Install the mini riser with either the Home or Joplin into one of the recesses in the interactive riser. Step 2. Use the torque screwdriver to install 2x M4 through the base of the interactive riser and into the mini riser securing it in place. Repeat steps 1 and 2 with the other mini riser.
Installation Instructions Page 6 Step 1. Place the interactive riser onto the display table. Make sure the threaded rods, power cable and the registration blocks go into the slot in the table. Step 2. Install the plate onto the threaded rods until plate is flush with the underside of the display table. Step 3. Install the two butterfly nuts onto the threaded rods. Tighten the plate onto the underside of the table by hand. Step 4. Plug the power cable into the nearest power socket.
Updating the Joplin Page 8 Updating the Joplin Page 9 Step 1. Press the left side of the cover inwards to lever the cover open. Step 2. Use your finger to power the interactive riser off. Step 5. Lift the display away from the table. Step 6. Insert the USB into the correct port (depending on what side the joplin is installed). Step 3. Remove the 2x butterfly nuts by hand and put them to one side. Step 4. Remove the plate and put it to one side. Step 7.
Updating the Home Page 10 Step 1. Power off the riser. Step 2. Insert the USB into the correct USB port (depending where the Home is installed.) Step 3. Press and hold the reset button on Home or Joplin. For the Home, the button is on the back side. It is the only button on Home. Step 4. Power on the riser and in about 10 seconds the 2x white LEDs turn on. The LEDs are located on the top on both devices. Step 5. Release the reset button once the 2x LEDs are ON.
Updating the System Software and System Reset Page 12 To update the system software plug a micro USB cabkle into the Micro USB OTG port located on the rear of the display and plug the other end into a P.C. Transfer the update from your P.C onto the riser, once transfer is complete the Interactive riser updates automatically. Remove the Micro USB from the OTG port.
Functionality Test Page 14 1. Are all package accessories included in the package? Y/N 2. Are there are blemishes or damage to the display? Y/N 3. Does the display play the video loop automaticaly Y/N? If not refer to the trouble shooting guide on page 13 in this manual. 4. Are the Home and Joplin synced to the video loop? Y/N FCC Statement This device complies with part 15 of the FCC rules.