Cortlin Fire Pit Table Installation Instructions for Cortlin Fire Pit Table COR-1264 1
IMPORTANT Contents Please consult your Crystal Fire instruction manual for detailed instructions and important information related to the burner Required Tools…………………………….…..2 installation including: lighting and operating instructions, safety information, and proper tightening of connections with two wrenches. Included with your Fire Pit……………….3 DO NOT ATTEMPT TO Instructions………………….………4 INSTALL CRYSTAL FIRE BURNER WITHOUT Assembly FIRST CONSULTING THE CRYSTAL FIRE OWNER’S MANUAL.
Included with Your Fire Pit Cortlin 1264 base (Control Panel Installed) COR-1264-BASE Two Piece Glass Cover 1264-GGC 1264 Crystal Fire Burner CF-1264 Black Key (BF-KY-05) Refer to Crystal Fire Manual for items included with crystal fire burners.
Assembly Instructions 1. Un-packaging Do not discard any packaging until assembly is complete and unit is tested. Keep all included manuals in a safe place for future reference. 2. Base Placement Place base in desired final location. Place on a hard, flat surface. Avoid soft surfaces and areas that collect water. Refer to Crystal Fire Manual included with your Crystal Fire Burner for safety information regarding the placement of your fire pit. 3.
4. Gas Connections Read and understand your Crystal Fire owner’s manual before beginning burner hookups or using the device. Do not use Teflon tape or pipe dope on flare fittings. • Reach inside the base and attach gas supply line to the input shown below, using a 1/2” flare fitting. Use two wrenches to ensure a gas tight connection.
TIGHTEN ALL CONNECTIONS SECURELY WITH TWO WRENCHES • Attach flex line from the burner to gas valve as shown below. Use two Wrenches to secure connection.
5. 6. Electrode Installation Plug both BLACK wires hanging from the burner into the back of the CF-SPARKER. If an orange wire is present, do not use it. The orange wire is for Direct Spark Ignition system only. Test system by pushing the button on the igniter. Consult the troubleshooting section of the Crystal Fire Burner Owner’s Manual, if the spark is weak, intermittent, or not present.
7. Fire Media Installation Scatter all included glass beads, lava rock, or other approved fire media evenly across entire burner surface. DO NOT OPERATE CRYSTAL FIRE BURNER WITHOUT INCLUDED GLASS BEADS OR OTHER APPROVED FIRE MEDIA 8. Glass Cover Installation • Carefully lay both pieces of the two piece glass cover on top of burner. Make sure burner is cool before attempting to place glass cover.
. Operating Instructions Before operating your Cortlin 1264 fire pit, ensure all gas connections are properly tightened and thoroughly leak checked. Refer to the Crystal Fire Manual for information on proper leak checking and other critical safety information. With the valve on the fire pit in the OFF position, open the valve on the propane tank or natural gas supply. Double check to make sure there are no gas leaks at the regulator or inlet side of the valve.
IMPORTANT Please consult your Crystal Fire instruction manual for detailed instructions and important information related to the burner installation including: lighting and operating instructions, safety information, and proper tightening of connections with two wrenches. DO NOT ATTEMPT TO INSTALL CRYSTAL FIRE BURNER WITHOUT FIRST CONSULTING THE CRYSTAL FIRE OWNER’S MANUAL.
Thank you for purchasing an Outdoor GreatRoom Company product! This fire pit was made with pride in the USA. Warranty: Fire pit tables are covered under a 1year manufacturer’s warranty. Please visit http://www.outdoorrooms.com/warranty-form/ to register your product. 14400 Southcross Drive West • Suite 100 • Burnsville, MN 55306 Toll Free: 1-866-303-4028 • Sales@OutdoorRooms.