User's Manual

4”
2”
PMS 109
Process Black
Step 1
Step 2
Final
POWER BANK
POWER BANK
6”
Project Name: INSERT CARD POWER BANK QUICK START GUIDE
Date: 4.28.2020Part #: 20-55265 Rev: A
Colors Coatings and Treatments: Notes:
Accordian Fold
Dieline and material shall follow: 23-84697
Designer: Rowell
Confidential property of Otter Products LLC
Reproduction and unauthorized use is prohibited
Otterproducts LLC:
209 South Meldrum Street,
Fort Collins,CO 80521
NOT FOR PRINT -
FOR REFERENCE ONLY
Dielines-
do not print
Folds-
do not print
POWER BANK
QUICK START GUIDE
OBFTC-0041-A
CHARGEUR
PORTATIF
GUIDE DE
DÉMARRAGE RAPIDE
20-55265_A
COMPLETE USER MANUAL
MODE D’EMPLOI COMPLET
OTTERBOX.COM/SAFETY-INSTRUCTIONS
DE Gesamtes Benutzerhandbuch
IT Manuale Utente Completo ES Manual de Usuario
Completo PT Manual do Utilizador Completo
JA
ユーザーマニュアル KO 사용 설명서
ZHT 完整版使用者手冊 ZH 完整版用户手册
When not charging, press button to view capacity
(Fig. 2):
• No LEDs – 0% capacity
• 1 flashing LED – 0-10% capacity
• 1 solid LED – 10-25% capacity
• 2 solid LEDs – 25-50% capacity
• 3 solid LEDs – 50-75% capacity
• 4 solid LEDs – 75-100% capacity
FULLY CHARGE FOR FIRST USE
While charging display continually shows (Fig. 1):
• 1 flashing LED – < 25% capacity
• 1 solid LED, 1 flashing LED – 25-50% capacity
• 2 solid LEDs, 1 flashing LED – 50-75% capacity
• 3 solid LEDs, 1 flashing LED – 75-99% capacity
• 4 solid LEDs – 100% capacity
CHARGE DEVICES
Power bank automatically starts charging
most devices.
WIRELESSLY CHARGE DEVICES
(IF APPLICABLE)
Press button and place your device flat
on the side of the Power bank featuring the
OtterBox logo.
An orange light blinks while detecting your device
and stops blinking if the device is not detected.
The orange light blinks when a device is
connected and charging.
CARE & MAINTENANCE
Cleaning
1. Wipe with a dry cloth.
2. Do not use solvents, chemicals, cleaning
solutions, alcohol, ammonia or abrasives.
CUSTOMER SERVICE
18556887269
USA + Canada - Toll Free
[e-mail]
otterbox.com/support
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
SERVICE À LA CLIENTÈLE
18556887269
É.-U. + Canada - Gratuit
[e-mail]
otterbox.com/support
Cet appareil est conforme à la section 15 des
réglementations de la FCC. Son fonctionnement
est soumis aux deux conditions suivantes :
(1) cet appareil ne doit pas causer d’interférences
nuisibles ; (2) cet appareil doit accepter toute
interférence reçue, notamment les interférences
susceptibles d’occasionner un fonctionnement
indésirable.
FIG. 1
FIG. 2
changes or modifications not expressly approved
by the party responsible for compliance could void
the user’s authority to operate the equipment.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment
and receiver.
-- Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV
technician for help.
ISED compliance statement
This device contains licence-exempt
transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference,
including interference that may cause undesired
operation of the device.
L’émetteur/récepteur exempt de licence contenu
dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement
économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
Radiation Exposure statement
This equipment complies with FCC/IC RSS-102
radiation exposure limits set forth for an
uncontrolled environment. This equipment should
be installed and operated with minimum distance
20 cm between the radiator and your body.
Cet équipement est conforme aux limites
d'exposition aux radiations FCC/IC CNR-102 établies
pour un environnement non contrôlé. Cet
équipement doit être installé et utilisé avec une
distance minimale de 20 cm entre le radiateur et
votre corps.