Installation Procedure C020 BLE—ES3016
ES3016 Telemetry I2C interface with BT transceiver for multiple sensor and control capabilities INPUT FEATURES I2C bus with Bulk M12 for Hall effect, Thermal or level sensors • Auto-Pairing to any Otodata ready sensor REPORTING & OUTPUTS • Android and IOS apps Measured parameter (5% variation) Low battery High/Excessive variation Temperature Data Interface Raw data Client mobile app Automated Testing Connection status Battery status ELECTRICAL SPECIFICATIONS Battery Pack • Ready to install ENVIRO
Label on Device: M/N: ES3016 F/W: 1.0 Barcode IC: 12649A-BEHT3AD FCC ID: 2ADQFBEHT3AD ISED non-interference disclaimer This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: 1. This device may not cause interference 2. This device must accept any interference, including interference that may cause undesired operation of the device.
Installation of the device 1. Unpack your device and ensure all parts look good with no damage. 2. If the sensor was shipped disconnected from the box, you can connect it now. Look for the correct position of the connector by aligning the half moon marks. Sensor Connector 3. Proceed to the Bluetooth pairing by downloading the Otodata TechApp, available for Android or IOS. 3.
3.3 Confirm 3.2 Select BLE Pairing This process will link your Otodata ES3016 to this Smartphone. BLE Pairing My Tank 3.5 Once the process is finished you will be able to use your device in the regular Nee-Vo app. 3.