Quick Installation Guide

ManualsBrandsOticon ManualsElectronicsHearing Aid Module

Table Of Contents

Oticon Radio Model - Regulatory Label Information for USA & Canada
- This device complies with Part 15 of the FCC Rules and with RSS-210 and RSS-247 of Industry Canada.
  - Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
Oticon Radio Model - Regulatory Label Information for Japan

PEOPLE FIRST

Oticon Radio Model - Quick Installation Guide

Radio Model Name:

Aurora miniRITE 312 T Rc

Oticon A/S

Main +45 39 17 71 00

Kongebakken 9

Fax +45 39 27 79 00

DK-2765 Smørum

Denmark

www.oticon.com

CVR-no. 42334219

The Aurora miniRITE 312 T Rc radio model contains two radio transceivers running at 3.84 MHz and 2.4 GHz and both implemented on a single hardware platform.

The radio model is implemented in an engine module mounted on the

main PCB with connections to the antennas, the microphones, the speaker

and the battery terminals. The radio model can be seen in 3D overview to

the left:

The 3.84 MHz radio is a low power, short range, inductive radio

transceiver working at a single channel at 3.84 MHz using MSK

modulation with 320 kbit/s data rate and connected to a small coil

antenna. The 2.4 GHz radio is a Bluetooth Low Energy (BLE)

transceiver using GFSK modulation with 1 Mbit/s data rate also capable

of proprietary receiver modes with higher data rates and connected to a

short wire antenna.

Aurora miniRITE T 312 Rc Radio Model – 3D overview

Summary of content (5 pages)

PAGE 1
PEOPLE FIRST Oticon Radio Model - Quick Installation Guide Radio Model Name: Aurora miniRITE 312 T Rc The Aurora miniRITE 312 T Rc radio model contains two radio transceivers running at 3.84 MHz and 2.4 GHz and both implemented on a single hardware platform. The radio model is implemented in an engine module mounted on the main PCB with connections to the antennas, the microphones, the speaker and the battery terminals. The radio model can be seen in 3D overview to the left: The 3.
PAGE 2
PEOPLE FIRST Oticon Radio Model - Quick Installation Guide Radio Model Name: Aurora miniRITE 312 T Rc Below the main flex PCB of the Aurora miniRITE 312 T Rc radio model with the most important electrical and electro-mechanical components can be seen: Aurora miniRITE T 312 Rc Radio Model – Main PCB – Top side The most important part of the radio model is the Engine Module mounted on the main flex PCB, which connects it to both the EEPROM memory and all external connections: On the top side these are th
PAGE 3
PEOPLE FIRST Oticon Radio Model - Quick Installation Guide Radio Model Name: Aurora miniRITE 312 T Rc On the bottom side of the main PCB of the Aurora miniRITE 312 T Rc radio model the connector for the speaker unit assembly (where the wire antenna for the Bluetooth radio is an integrated part), the programming connector, EEPROM memory and coil antenna for the 3.
PAGE 4
PEOPLE FIRST Oticon Radio Model - Regulatory Label Information for USA & Canada Radio Model Name: Contains: Aurora miniRITE 312 T Rc FCC ID: U28AUMRTRC IC: 1350B-AUMRTRC NOTICE: This device complies with Part 15 of the FCC Rules and with RSS-210 and RSS-247 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
PAGE 5
PEOPLE FIRST Oticon Radio Model - Regulatory Label Information for Japan Radio Model Name: Aurora miniRITE 312 T Rc Description: Radio module with 2.4 GHz low power transceiver to be integrated into Oticon, Bernafon, Sonic hearing instruments and associated devices. NB: The regulatory label for Japan is also included in the IFU for Japan. The grant number is an example.