Copyright © 1998 OTC Telecommute Inc., San Jose, CA. Ali rights reserved. This manual is copyrighted with ail rights reserved. No part of this publication may be reproduced. transmitted, transcribed, stored in a retrieval system or translated into any language in any form by any means without the written permission of OTC Telecommute, Incorporated. Trademarks AIfEZY2411 elan Bridge, the Warez logo, OTC Telecommute Inc., and the OTC Telecommute logo are trademarks of OTC Telecommute, inc.
on the outside of the box. OTC Telecommute cannot be held responsible for any product returned without an RMA number, and no product will be accepted without an RMA number.
DECLARATION OF CONFORMITY We OTC Telecommute Inc., 2036 Bering Drive San Jose, CA, 85131 Telephone: Declare under our sole responsibility that the product Airedale-BRG Complies with part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
CONTENTS 1.0 INTRODUCTION 2.0 SYSTEM REQUIREMENTS 3.0 PRODUCT PACKAGE 4.0 INSTALLATION OVERVIEW 4.
1.0 Introduction Congratulations on your purchase of OTC Telecommute Airedale elan Bridge! The Airedale elan Bridge is a cost effective “plug and play” wireless Ethernet Bridge that can provide wireless network connectivity when people and information are scattered among several nearby buildings within a few of miles {line of sight is required between the two connectivity points). OTC Telecommute wireless bridge provides wireless point to point connectivity and high performance.
1 diskette Diagnostic and Configuration Software Custer configurations: Please see Packing List enclosed with shipping boxes 4.0 Installation Overview After removing Airedale elan Bridge from the shipping box, be sure to lay out all the contents to ensure that all necessary components are accounted for before you begin the installation process. Refer to Section 3.0 of this manual for a complete list of provided components.
We recommend that the user familiarize themselves with the wireless bridge hardware and review the HELP menu on the Diagnostic Configuration diskette before attempting any re-configurations Configuration Guide: 1) Connect the ArEZY2411 tan Bridge units to a PC’s Ethernet port via a straight-through UTP cable Run the diagnostic program In the Diagnostic program's main menu, select item Control and Can fig. A configuration will pop up.
4) Run the RF cable along the antenna mast to where the Airedale lan Bridge unit will be located 5) Secure the cable approximately away from the Airedale elan Bridge unit to allow for stress relief along the RF cable. (Connecting the RF cable to the unit without stress relief in place will damage the connector assembly on the AIfEZY2411 elan Bridge units!) After you have completed the installation of the antenna systems, please refer to the user's manual for the network connection.
[alg Lizzie 28x :f = g252=4 £5 5B) fee WHEN PLACING ANTENNA OR MAST, MAZE CHURL THE AREA OVERHEAD &§ CLEAR OF POWER LINES.