OSD AU D I O Rock Speaker Owner’s Manual Tools needed for installation Speaker wire - To determine the length and the gauge of speaker wire, you will need to measure the distance between your receiver/amplifier and the speakers. Trench Spade/Shovel Wire Cutter Measuring Tape Outdoor Volume Control (Optional) Direct Burial Cables Silicon Cable Connectors (Optional) - Always buy more than you think you would need. - Equal wire lengths should always be used to maintain an equal balance in sound volume.
Step 5 When connecting any speakers to the amplifier or receiver, always make sure the power is off. Locate the connection terminals on the back of your receiver or amplifier. Always make sure to connect audio out from the back of your receiver or amplifier to the speakers. Not all receivers/amplifiers can safely operate 2 pair of speakers at the same time. It is important that the amplifier or receiver’s output wattage is comparable to the speaker’s power handling.
Specifications Rock Speaker RS850 RS850TT RS840 RS810 Speaker Type: Sold as: Warranty: Weather Resistant Reference Rock Speaker 8” Polypropylene Cone Woofer with Sealed Voice Coil 2” Coaxial Polyamide Dome 8 Ohm 20Hz – 20kHZ 300 Watts 91dB H 15” x W 19” x D 16” 28 lbs Canyon Brown & Granite Grey Each 1 year Weather Resistant Dual Tweeter Stereo High Power Rock speaker 8” Polypropylene Cone Woofer with Sealed Voice Coil Two 1” Tweeter Mounted 18 Degrees 8 Ohm 28Hz – 21kHZ 400 Watts 89dB H 15” x W 20”
Specifications RX640 RX550 RX540 Weather Resistant Multi Purpose Rock Speaker 6 ¼” Polypropylene Cone Woofer with Sealed Voice Coil 1 ” Coaxial Polyamide Dome 8 Ohm 39Hz – 22kHZ 150 Watts 91dB H 8 ½” x W 7” x D 9” 7 lbs/pack Canyon Brown & Granite Grey Pair 1 year Weather Resistant Multi Purpose Rock Speaker 5.25” Dual Polypropylene Cone Woofer with Butyl Rubber Surround None 8 Ohm 65Hz – 20kHZ 100 Watts 88dB H 8” x W 9” x D 9” 11.