Bluetooth Keypad DFB01 User’s Manual
About This Manual This manual is designed to assist you in installing and using the Bluetooth Keypad. Information in this document has been carefully checked for accuracy; however, no guarantee is given to the correctness of the contents. The information in this document is subject to change without notice. Edition 1st Edition, Copyright © Copyright 2016 This document contains proprietary information protected by copyright. All rights are reserved.
FCC RF Radiation Exposure Statement: 1.This Transmitter must not be co‐located or operating in conjunction with any other antenna or transmitter. 2.“For body worn operation, this device has been tested and meets FCC RF exposure guidelines. When used with an accessory that contains metal may not ensure compliance with FCC RF exposure guidelines.
Package Contents Bluetooth keypad User’s manual Power Switch There is a power switch at back of the keypad. When not in use, please turn to OFF to save battery power Note: 1. After 30 minutes non-operation, the keypad will go to low-power mode. Please press any key to wake up and wait the blue LED turn off before using. 2. Power ON/OFF also need to press any key to reconnect and wait the blue LED turn off before using. Device pairing 1. Turn on the Bluetooth connection on the device 2.
Device pairing 1. Right click on the BT icon and choose “Explore My Bluetooth Places” 2. Press the ‘Conn’ button at bottom of the Bluetooth keypad, then the led will start flashing. 3. Click the “Search for devices in range” option, the “keypad” will be found. 4. Double click on the “Keypad” icon, it will pop‐up another windows. Just follow the screen display to input the Pin Code then press “enter” (the keypads enter). 5.
Toshiba software: 1. Right click on the BT icon and choose “Add New Connection” 2. Press the ‘Conn’ button at bottom of the Bluetooth keypad, then the led will start flashing. 3. Click “Next” 4. Choose the “Keypad” device and click “Next” 5. Just follow the screen display to input the Pin Code then press “enter” (the keypads enter).
6. Click “Next” 7. The Found New Hardware Wizard appears and the OS will install the driver automatically. No other steps are necessary. 8. The Bluetooth icon will become to . The Bluetooth keypad is ready to use.
IVT Software: 1. Press the ‘Conn’ button at bottom of the Bluetooth keypad, then the led will start flashing. 2. Double click the BT icon on the system tray and it wills pop-up a windows. Choose “My Bluetooth” → ” Bluetooth Device Discovery” 3. It will find the “Keypad” device. Right click on the keypad icon and choose “”Connect” → ” Bluetooth Human Interface Device Service” 4. Just follow the screen display to input the Passkey then press “enter” (the keypads enter). 5.