P/N 817407450 Revision A FuelOmat Gold µDataPass Installation Manual
FCC Compliance Statement The FCC Wants You to Know: This equipment has been tested and found to comply with the limits for a Class A & B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
TABLE OF CONTENTS Paragraph 1. 2. 3. 4. 5. 6. Page SCOPE....................................................................................................... 4 GENERAL DESCRIPTION......................................................................... 4 AVAILABLE CONFIGURATIONS .............................................................. 4 SPECIFICATIONS ..................................................................................... 5 µDATAPASS PINOUT ..........................................
1. SCOPE This document describes the the mechanical installation of Orpak's µDataPass, part of the FuelOmat Gold Wireless Vehicle Identification System. 2. GENERAL DESCRIPTION The µDataPass (see Figure 1) unit collects accurate data from the vehicle on-board computer bus (OBDII) and transmits it to Orpak's Wireless Gateway Terminals (WGT) while refueling, or whenever the vehicle passes next to the WGT installed at the fleet facilities.
4. SPECIFICATIONS (See Table 2) Table 2. μDataPass Specifications Parameter Value Physical Height 22.1 mm Width 41.3 mm Depth 16.8 mm Weight 8g Connectors OBDII compatible (male) Supply voltage Normal operation: 12VDC (Nominal) Minimum: 9 VDC Maximum: 16 VDC Current consumption (typical) Sleep mode: 4mA Active mode: 55mA Temperature Range Operating: -40 to +70 ºC Electrical Environmental Conditions Storage: -40 to +85 ºC Wireless Interfaces Single IEEE802.15.
5. µDATAPASS PINOUT Table 3 details the µDataPass connector pinout Table 3. µDataPass Pinout Pin # Pin Name Description 16 VIN+ Supplied voltage (+) 4 VIN- Supplied voltage (-) 7 K-line (ISO) Utilized for K- line protocol 6 CAN H For Can Bus protocol, connect to 'CAN H' in the vehicle bus 14 CAN L For Can Bus protocol, connect to 'CAN L' in the vehicle bus 6. INSTALLATION PROCEDURE µDataPass installation is a very simple process.
Figure 3. Plugging the μDataPass 3. Reassemble the panel that covers the Diagnostics connector.
