User's Manual

ManualsBrandsOrpak Systems ManualsElectronicsDATAPASS

Table Of Contents

FCC Compliance Statement for DataPass/µDataPass 1

DataPass & µDataPass

P/N 817407400

Rev A2

1. SCOPE

This document provides a general and functional description of the DataPass and

µDataPass units.

2. DATAPASS & µDATAPASS DESCRIPTION

DataPass and µDataPass are miniature units that connect to the vehicle bus and

capture data from the vehicle CPU/BUS. They then transmit this data to the nearest

Wireless Gateway in the forecourt. Two unit types are available for the installer (see

Figure 1 and Figure 2):

µDataPass (CAN) for CAN Bus Protocol

µDataPass (k-line) for K-line Protocol

Figure 1. µDataPass

DataPass for Light Vehicles (OBD-II)

DataPass AVL for Heavy Vehicles

Figure 2. DataPass

Summary of content (6 pages)

PAGE 1
DataPass & µDataPass P/N 817407400 Rev A2 1. SCOPE This document provides a general and functional description of the DataPass and µDataPass units. 2. DATAPASS & µDATAPASS DESCRIPTION DataPass and µDataPass are miniature units that connect to the vehicle bus and capture data from the vehicle CPU/BUS. They then transmit this data to the nearest Wireless Gateway in the forecourt.
PAGE 2
µDataPass – a connector shaped unit that plugs into the vehicle On Board Diagnostics connector (OBD II) and intended for light and commercial vehicles which has OBD II connector. The following µDataPass types are available:  µDataPass CAN, P/N 800907435  µDataPass K-Line, P/N 800907436  µDataPass Plus CAN, P/N 800907430  µDataPass Plus K-Line, P/N 800907431 DataPass - connected directly to the vehicle bus harness, used in heavy and light vehicles and supports most common bus protocols.
PAGE 3
Parameter Value Maximum: 32 VDC Current consumption (typical) KLINE Mode: Sleep mode: 5mA Active mode: 35mA CAN Mode: Sleep mode: 5mA Active mode: 25mA J1708 Mode: Sleep mode: 5mA Active mode: 25mA Temperature Range Environmental Conditions Operating: -40 to +70 ºC Storage: -40 to +85 ºC Humidity 95% non-condensing Wireless Interfaces Single IEEE802.15.4 wireless channel Operating Frequency: ISM 2.405 to 2.480 GHz (Global license free band) Implements proprietary mesh network IEEE802.15.
PAGE 4
Table 2.μDataPass Specifications Parameter Physical Value HxWxD 22x70x17 mm Weight 10g Connectors OBDII compatible (male) Supply voltage Normal operation: 12VDC (Nominal) Minimum: 10 VDC Maximum: 32 VDC Electrical Current consumption (typical) KLINE Interface: Sleep mode: 4mA Active mode: 35mA CAN Interface: Sleep mode: 4mA Active mode: 25mA Environmental Conditions Temperature Range Operating: -40 to +70 ºC Storage: -40 to +85 ºC Wireless Interfaces Single IEEE802.15.
PAGE 5
FCC COMPLIANCE STATEMENT IN USER'S MANUAL This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 6
Sample user information for a Class B digital device THE FCC WANTS YOU TO KNOW: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential area.