Contents For the User Safety instructions Information de sécurité General advice 3 4 5 Damage in transit Applications Protecting the machine against freezing 5 5 5 Operating instructions Test the machine by running a cycle 6 Care and cleaning 7 Rinse conditioner dispenser Spray arm Coarse strainer Fine filter Detergent dispenser Cleaning 7 7 7 7 7 7 Loading Controls and programme table In the event of a fault 8 9 13 Trouble shooting list 13 Service and spare parts 14 For the Installer Instal
Safety instructions Please read all instructions before using your dishwasher. Use your dishwasher only as instructed in this Use and Care Manual. Installation and grounding instructions are included with your new diswasher for the installer´s reference. • To avoid entrapment and/or suffocation, remove the door from any dishwasher that is discarded or otherwise not in use. • Do not wash plastic items unless marked ”dishwasher safe” or the equivalent.
Information de sécurité Lisez attentivement cette notice et prenez connaissance des indications, conseils et mises en garde concernant l’installation et l’utilisation de votre lave-vaisselle. Pour éviter les erreurs et accidents inutiles, il est important que tous ceux qui utiliseront le lave-vaisselle en connaissent bien le fonctionnement et les dispositifs de sécurité. AVERTISSEMENT • Cet appareil doit être mis à la terre.
THANK YOU for choosing a new Origo dishwasher. We hope it will give you every satisfaction. Please read through these instructions carefully. You will then quickly learn how to use the machine and make the most of its features. Pull up a chair beside the machine so that you can familiarise yourself with the various controls and functions as you read the instructions. Note! Save these instructions.
Operating Instructions Test the machine by running a cycle 1. Scrape or rinse off solid food 2. Load the dishwasher. remnants. (See page 8: "LOADING") Fill up the rinse conditioner dispenser. Put the correct amount of detergent on the inner door. 4. Start the dishwasher by tur- 3. Close the door. ning the programme knob to the start position. 5. Check the strainers to see whether they need cleaning when the dishwasher has finished the wash.
Care and cleaning 1 2 3 4 5 Rinse conditioner dispenser (1) Coarse strainer (3) Use of a rinse conditioner will result in cleaner and faster drying of the load, since it helps water and soil to run off. Too much conditioner may result in streakiness, too little may cause white spots. The dispenser holds about 140 ml. This is enough for 40-70 wash cycles, depending on the dosage setting. When the rinse conditioner level is approaching the bottom of the scale it is time to refill the dispenser.
Loading How to load the dishwasher The illustration shows the machine loaded with five place settings. Your own dishes are not likely to be identical to this load, but if you follow the advice below we are sure you will be pleased with the results. - Always place glasses, cups and bowls upside down. - Incline deep dishes (soup plates etc.) so that the water can run off when drying. - Make sure that the dishes do not rest against each other.
Controls and programme table 1 1 Selector knob To start the machine: - Turn the selector knob to the programme start. The ON/OFF switch is built into the programselector. To isolate the dishwasher from the electric circuit completely, unplug it from the wall socket. Door lock To open the door, press the handle down. Avoid opening the door when the machine is running. If you open the door a little when the dishwasher has finished washing, the dishes will be just as dry after a short while.
Installation Countertop Use Positioning In its standard version the machine is intended for installation on a kitchen counter or worktop. TO FUNCTION PROPERLY THE MACHINE MUST BE FULLY LEVEL. Its height can be adjusted with the adjustable feet (8 mm each). Water supply The temperature of the water supply should not exceed 150° F and the pressure should be between 5 - 142 lbs/sq inch. It is important to have a faucet positioned close to the machine and with easy access.
Installation Built-In Use Installation Tips Direct from the box, the dishwasher may be installed in a built-in manner. The use of the Origo Built-In Kit is recommended. Clean dishes require adequate hot water. Supply water temperature of 140° F (60° C) is desirable; 120° F (49° C) is minimum; 150° F (65° C) is maximum. A minimum water supply line of 3/8” (outside diameter is recommended. Water pressure should be 5 - 142 PSI. A separate 15 Amp, grounded 115 V AC electrical supply is required.
Installation Built-In Use Installation Tips Discharge connection Connection to Sink Drain Connect the discharge hose to the pipe stub at the rear of the dishwasher, using the hose clamp supplied. It is important to push the drain hose onto the drain port as far as possible. It is recommended that the dishwasher drain be connected to either an existing sink drain or disposal. Local codes may require that the drain line be connected to house plumbing with a drain air cap.
In the event of a fault Trouble shooting list • If water leaks from the machine • Turn off the water supply tap or stopcock immediately and isolate the machine from the electrical supply by removing the plug from the wall socket. • Check that all seals, seams and connections are watertight. There is always a certain risk of leakages in any machine connected to a water supply, no matter what water safety features it may have.
Service and spare parts If you still cannot remedy the problem after following the steps above, call a repairman. Service and spare parts can be ordered from your dealer. There you will also be able to obtain advice on how to rectify the fault yourself, if possible. Before calling the dealer or a service centre, make a note of the details on the data plate affixed to the rear of the dishwasher.
- 15 -
99-09