BLUEDRIVE S POWER FINTM User’s Guide PF-240S WARNING For your own safety and that of your equipment, make sure to take the following precautions. Failure to follow warning notices and instruction may result in property damage, serious injury or death. Please keep the manual and read it carefully before using the product; If the manual is lost, please contact our after-sale service center. aquamar ina.
TABLE OF CONTENTS I. SAFETY WARNING II. MAIN COMPONENTS, PARAMETERS AND OVERALL DIMENSIONS III. PACKING LIST IV. INSTALLATION AND INSTRUCTION V. MAINTENANCE VI. GUIDANCE ON PROBLEMS VII.
SAFETY WARNING 1.This product is only for providing power for water leisure products and only limited to be used in water. It is forbidden to use it for other purposes. 2.When using the product, a proper emergency stop leash should be used 3.Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. 4.Do not modify the product or add other parts to it in any way. If any parts is damaged, Please contact after-sale service center. 5.
FCC ID: 2AVFRPF-240S FCC statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
POWER FIN PRODUCT DETAIL: Metal connector Motor protective cover Motor Motor protective cover Motor propeller Guide vane
PARAMETERS Operating Speed: 4-6km/h Underwater Jet • Low gear : Max. Speed 4km/h • High gear : Max. Speed 6km/h Runtime: 1h for low gear, 0.5h for high gear Protective Cover Material: ABS Dimension: 300 x 210 x 110mm (11.8” x 8.3” x 4.3”) Weight: 2.5kg (5.5lbs) Battery Case Rechargeable Battery Pack: 11.1VDC, 8.8Ah/97.68Wh Special lithium-ion battery for BlueDrive S Power Fin Material: watertight, flame retardant ABS Battery Life: ≥300 cycles Dimension: 210 x 155 x 75mm (8.3” x 6.
PACKING LIST No.
INSTALLATION AND INSTRUCTION 1. Open the packing box and check whether the components are complete 2. Install power fin into Desired device (As shown in the picture) Desired device; 2.1 Insert the bottom of power fin into the fin base of 2.2 Insert the slide in push-in pin into the fin base; 2.1 2.2 3. Install the battery case Firstly check whether the battery case is with electricity (please refer to the manual of Magnetic Switch for details).
a. Insert the power cord of the charger into the corresponding hole position on the charger to charge the battery case. b. Screw off the metal nut on the back of the battery case counterclockwise; c. Connect the metal plug on the charger to the corresponding connector on the battery case (Please note the direction of convex and concave corresponding position) and tighten the nut; d. Plug the power plug of the charger into the home power supply. e.
5. Remote control 5.1 Please pull out the insulation layer (a transparent sheet) from the remote control before first use. 5.2 Loading the remote control into waterproof sleeve, and put it on the arm (as shown in the following picture) 5.3 Note: For the remote control, the effective distance is under 10 meters. 5.1 5.2 5.4 Operations of Remote Control: a. : Start and operate at low gear b. : Start and operate at high gear c. : Stop (Note: This is NOT a “start” button.
6. Magnetic Switch Cord 6.1 The magnetic switch cord is a 2-in-1 design, working as both power switch and emergency stop switch. 6.2 For standby mode, snap the magnetic switch in the right position of the battery case, and the indicator light will flash blue for 5 times and turn solid blue to display the remaining battery. The remaining battery is roughly indicated by the number of dots: 4-dot for nearly 100% battery, 3-dot for nearly 75% battery and so on. 6.
MAINTENANCE Maintenance part Time interval Maintenance process Remote control Every month Underwater jet After each use Check the residues wrapped in propeller, if yes, please clean it Battery Case After each use Wipe it with a rag and dry it If you don't use it for a long time, please remove the battery; Do not open the battery case by in any Battery Case In any case The back side of After each use cases. Please contact a local dealer or an after-service center for the battery maintenance.
this product for environmental safe recycling. No. Problem description Solutions 1 The remote control does not work 1. Check whether the battery is good and loaded properly 2. Check if the insulation layer is removed. 2 The charger does not work Check whether the connection of the aviation plug is reliable. 3 The booster does not work 1. Check whether the aviation plug between the motor and the battery case is reliable; 2. Check whether the magnetic switch is assembled.