Quick Start Guide

Dual Access Modes
Orbitkey Nest has a unique dual-function hinge that
allows you to use it in 2 ways:
Customising the Internal Storage
Use the included movable dividers to customise
compartments in the bottom tray to suit your items.
01
Stationed
Lift the lid to separate
the two trays.
01
Placing Dividers:
Once in desired position, push and twist to secure.
02
On the go
Flip Nest open
like a book.
Tip: We recommend arranging items in the tray before
placing the dividers.
99 mm
Welcome to
Orbitkey Nest
A home for your everyday essentials.
Quick Start Guide
FCC Statement
This device complies with part 15 and part 18 of the FCC Rules. Operation is Subject
To the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Changes or modifications not explicitly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
Note: this equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 and part 18 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and candidate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit diferent from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Using the wireless charger
01
Connect to power
source via USB cable.
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. During the operation of device a distance of 15 cm
surrounding the device and 20 cm above the top surface of the device must
be respected.
This device complies with Part 18 of the FCC Rules. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
02
Centre device
on charging pad for
optimal charging.
110 mm
• Increase the separation between the equipment and any other radio device.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.