Table of Contents ENGLISH + deduction + Getting Stated « Programming + Using the Rewrote Control Devi + Using tie Options] Reid Free senior. + stonewalling Indoor Mount Sprinkler Timer and Remote Control Device Sleeve BH * Diagnostics Circuit Breaker xe + Trouble Shooting . | OTWTMO0R598 57926.24 Tan dd 2 Section 1: Introduction ank you for selecting 80 Orbit? Signature Contra! chimes, the most advanced end versatile controller available.
No-Warmonger Days and Times Tes easy 0 prevent watering on. one of rare days of the week or during specific periods of the day. This comes in handy if watering restrictions are apposed in your area.
Programming Buttons These nine batons are used for programming aad other ons: ont view of timer Bl RF Sync (only on remote control model) Allows the thee ww synchronize with a new remote or wire less sensor, EI Rain Delay Push this Burton once while in AUTO 10 access the rain delay option. NOTE: is button wilt scenes the Language and No d captions while in those respective dial positions.
Activating the Batteries Slide the docking port off the timer unit 10 gain access to the battery compartment dao Side the door off the Barry accompaniment in the direction of the arrow, Remove the black strip from: the battery compartment Replace the brassiere Slide the docking port & end door, onto the main controller unit “The display will show "LOW BATTERY” when replace the batteries, MOTE: Batteries alone will nol operate the valves tn your sprinting system.
| ENTER £7 button. The display now reads * Set the current months by pressing either the DATE." Sat the current day of the enthrone hy pressing either the¥Es or [23 Futon, Exit dhe set lime and selection dial ce made at any he by turning the Determine a Watering Plan See page 20 for instructions. Section 3; Programming Your Timer Figure 2: Program A and Program B Dial Se tings Set Start Times IMPORTANT: Multiplier start times in ram A will repeat the ing program.
Set Watering Days * “Tum the selection dial 10 WATERY you wish 10 561 {A or BY. DAYS for the program Set to Water Days of the Week: Press the NEXT “button (© move troy; the week. The selected day wil flash. Press ENTER ard a water drop appears above that day of the week, The uproar: is now sel 10 warier on that day. The program can be seu son of days (ex. Mo, We, Fr). to wale any combo To deactivate watering for a participant day, press the CLEAR [1 bunion. The water drop will disappear.
ys. (For sample, in some water dietetics, watering is sited on certain days.) To cancel programmed watering on N/PER: ou will see the seven days of the week with a above each day: The water drop means watering on that particular day. the display, water do i nation > Press the NEXT "2 buses w select the day of the week you don't want 10 water. (The day will flash} Press the CLEAR (8) bunion.
duration 10 20 minute 160 mate duration wo 1 minute. ing of 10% will decrease a» Press the NEXT “button. « The display reads "MANUAL ALL” to the right of the levers he set water budgeting mode by timing ihe selection “a and B" ENGLISH xi dial. » Press the ENTER 7 burden. Test All Stations: Tate su with 2 set duration will water fn sequence.
Manual Watering Program B: This will allow yo ta water only those stations with set epidurals tn Program B. * With (ae dial in the ALTO posit buster. « Press the NEXT 5 bun en until the display reads “& MANUAL # Press the ENTER 27 bun. Each station will water, in sequence, ane after another, for the 5.
the current station: Lo the newt station in the cycle.
| » Press ON “X" MIN 10 water those stations for the desired Installing the Sprinkler Timer °K) nurse of nuttiness. a in Five Easy Steps To Cancel Remote Control Device Operation 1. Select a Location and Return Control to Timer: Select 2 Location with the following criteria » Near an electrical cuter. {Avoid using sn outlets rerecorded by a switch.) * Press the OFF/CLEAR button or the Remote Carol Device. This cancels ary current commands fom th and treasure console back to the timer.
2. Mount the Docking Port « Tide the tines off the sacking port. (See Figure 3) . Using the mounting template (included), mark the two screw locations on the vial, then dif holes at the karts for No. & screws. Us the expanding anchors In plaster or masons if necessary. Place the docking port against the wall, aligning the two holes in the dosing port with the two drilled holes. . Secure the docking port to the wall by screwing a No. 8 screw (included) through cache of the two holes. .
+ To avoid electrical hazards, only one valve should be connected wo each station IMPORTANT: The wire can be buried in the rowed. However, for greater protection, wires can by pulled through PYC pipe and butted underground. Be cared to avoid burying the wires in locations where they could be damaged by future digging or B. Comes Valve Wires to the Sprinkler Tin * Sep the plastic insulation off the end! of each wire.
* Secure the sleeve to the wall by screwing a No. 8 screw {included} through each of the two holes * Slide the remote control device into the sleeve. Section 7: Diagnostics Circuit Breaker SmartScan® Diagnostic Fault Sensing A diagnostic Fault sensor will automatically scan for the presence of a faulty solenoid or wiring hart in a valve during each water tag sequence.
Section 8: Glossary of Terms TERM DEFINITION Cycle Sta st Tin: “Th time the program begins watering the cycle Waster Valve A valve that prohibits water from reaching station valves.
1. For each station (or valve) write down the watering IMPORTANT: Be aware of any watering restrictions through location, the type of sprinkler head and the types of your local water district. ants 10 be watered. 3. Determine, based on step 2, the ideal watering option for each station. watered) and frequency for each sciatic. Based on (he preceding information your water program may Took like this.
Section 9: Trouble Shooting Symptom ns of more stations do nation oa Possible Causes of Problems. Correction i. Falsify Scion Replete solenoid 2, Wire broken of ot connected. Reps vice avd crock someones 3.
Help Before returning this sprinkler timer to the score, contact Grit Technical Service a: 1-600-198-6156, Listings The sprinkler timer is tested to UL-1951 (Models 57922, 57926, 51922, 91926, 34922. 94926) standard and is ETL» sifted. Appropriate international models ave C34% and CE approved. Oboe Irrigation Limited Six-Year Warranty rote Irrigation Products, Inc. Wants 16 its customers that its products will be free from defects in materials and workman. shi a period of six years fom the date of purchase.
For STORE SPRINKLER TIMER (57926, 57922, 57916 & 57912) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority fo operate the equipment.