Installation Instructions

Directions for use
Warning:
This device complies
with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may
cause undesired operation.
Note: This equipment
has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or
relocate the receiving antenna.
—Increase the
separation between the equipment and receiver.
—Connect the
equipment into an outlet on a circuit different from that to which the receiver
is connected.
—Consult the dealer
or an experienced radio/TV technician for help.
1. Automatic induction mode
Access to the sensor within 40 cm from above, then the cover will be
opened automatically. After removing, LED lights gradually fade and
turn off automatically.
2. Automatic changing and sealing bags
Long press the “Home” button for 3seconds. the garbage can will be
automatically packed. When the packing is completed, the cover will open
and the packaged garbage bag can be taken out.
3. Pet-proof Mode
FCC ID: 2AUD5-HERO