User's Manual
GX0301
AGENCY REQUIREMENTS
Licensed by QUALCOMM Incorporated under one or more of the following United States Patents and/or their counterparts in
other nations: 4,901,307; 5,490,165; 5,056,109; 5,504,773; 5,101,501; 5,506,865; 5,109,390; 5,511,073; 5,228,054; 5,535,239;
5,267,261; 5,544,196; 5,267,262; 5,568,483; 5,337,338; 5,600,754; 5,414,796; 5,657,420; 5,416,797; 5,659,569; 5,710,784;
5,778,338
Federal communications commission notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 22 and 24 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
>
Reorient or relocate the receiving antenna.
>
Increase the separation between the equipment and receiver.
>
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
>
Consult the dealer or an experienced radio or television technician for help.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved
by Option could void the user's authority to operate the equipment.
Declaration of Conformity for products marked with the FCC logo - United States only
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
For questions regarding your product or FCC declaration, contact:
Option | Gaston Geenslaan 14 | 3001 Leuven | Belgium
www.option.com
To identify this product, refer to the Part, Series, or Model number found on the product.
This product has successfully completed the PTCRB requirements governing the release of new GSM 850/1900 capable
products into the North American market.
Exposure Information to Radio Frequency Energy
This PCMCIA card has been tested in 3 different notebooks for compliance with the SAR requirements.
Measured SAR values according to the CE regulations:
The maximum measured body SAR value (averaged over a mass of 10 g and distance between phantom and antenna of 15 mm)
is well below the limit of 2 W/kg.
Measured SAR values according to the FCC regulations:
The maximum measured body SAR value (averaged over a mass of 1 g and no distance between phantom and bottom of the
notebook) is well below the limit of 1.6 W/kg.
This device contains 900/1800 MHz GSM/EDGE and 2100Mhz WCDMA functions that are not operational in U.S. Territories.
For safe and efficient use the user should keep the antenna of the card at a minimum distance of 20 cm away from his body.
CAUTION: Users concerned with the risk of Radio Frequency exposure may wish to limit the duration of their calls and to position
the antenna as far away from the body as is practical.
European Union declaration of conformity CE 0700
Products bearing the CE marking comply with the R&TTE Directive (99/5/EC), EMC Directive (89/336/EEC) and the Low Voltage
Directive (73/23/EEC) issued by the Commission of the European Community.