User's Manual

Table Of Contents

Swittons WiFi (w/ RFID) – User Manual

Part -1 – Mobile App & Configuration

• Open the Swittons Mobile App and click on Add new device(V2)

• On the next screen there will be the access point created by the

device named as “SWITTON_XXXXX” where XXXXX will be the MAC

address of the device.

• Click on the device name. On the next screen click on “Connect” to

connect mobile app to device.

• Once connected, user will be able to Provision device to WiFi of

choice.

• On clicking Provision, on the next screen user will see list of

available WiFi networks to choose from.

• On choosing the WiFi user will be prompted to enter the WiFi

password.

• Once the WiFi connection is successful, the device status LED will

turn GREEN.

Part-2- Authenticating and Usage of device

• Once the status LED turns GREEN, the device is ready to use.

• To start using the device, place an RFID card on the top panel of the

device.

• The device should make a beep sound indicating the recognition of

the RFID card, the buttons can now be pressed.

• In case, the user does not swipe/scan the RFID card, the button

presses will not be sent to the server.

PAGE 1
Swittons WiFi (w/ RFID) – User Manual Part -1 – Mobile App & Configuration • Open the Swittons Mobile App and click on Add new device(V2) • On the next screen there will be the access point created by the device named as “SWITTON_XXXXX” where XXXXX will be the MAC address of the device. • Click on the device name. On the next screen click on “Connect” to connect mobile app to device. • Once connected, user will be able to Provision device to WiFi of choice.
PAGE 2
• Each button press is accompanied by a buzzer sound and a BLUE LED blink over the button pressed to indicate the button press recognition. • Each RFID scan will be valid for 30 seconds, meaning after the user scan the RFID card, the button press window is 30 seconds after which the user will again have to scan/swipe the RFID card. However, a different RFID card can be scanned instantaneously which would then be valid for another 30 seconds.
PAGE 3
FCC WARNING This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.