User's Manual

Table Of Contents

Swittons Cellular Device – User Manual

Part 1:- Adding a SIM Card

• Open the SIM Card tray from the side of the device using a

standard SIM ejector tool or a paperclip.

• Carefully align the SIM card on the tray and put it in the device.

Part 2:- Starting the device

• Long press button 1 to turn the device ON.

• Users should be able to hear a beep sound when the device turns

on, this means that the device recognizes the SIM card.

• Once the device recognizes the SIM card, the network

status(lower) LED should turn BLUE, indicating that the device is

acquiring the LTE-M/2G network.

• Once the device successfully acquires the network the LED will

turn GREEN.

• After turning the device ON if the LED is RED, it means the device

cannot latch onto the network. Try moving to a more receptive

location.

• The Upper LED on the device indicates the charging status. While

charging, this LED should be RED.

• If the battery is low, the network status LED will blink BLUE until

the battery level reaches a predefined limit.

Part 3:- Authentication & Usage of the device

• Once the LED has turned GREEN, the device is ready to use.

• To start using the device, place an RFID card on the middle of the

top panel of the device.

PAGE 1
Swittons Cellular Device – User Manual Part 1:- Adding a SIM Card • Open the SIM Card tray from the side of the device using a standard SIM ejector tool or a paperclip. • Carefully align the SIM card on the tray and put it in the device. Part 2:- Starting the device • Long press button 1 to turn the device ON. • Users should be able to hear a beep sound when the device turns on, this means that the device recognizes the SIM card.
PAGE 2
• The device should make a beep sound which means the RFID has been read and the buttons can now be pressed. • In case the user does not swipe/scan the RFID card, the button presses will not be sent through to the server. • Each button press will be accompanied by a buzzer(beep) sound and a blue LED on the button pressed to indicate successful recognition of the event.
PAGE 3
FCC WARNING This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.