User Manual Part 3

OPTICON
User's manual
PHL-7000 series
3
-
4
3 sec 3 seconds
4 sec 4 seconds
5 sec 5 seconds
6 sec 6 seconds
7 sec 7 seconds
8 sec 8 seconds
9 sec 9 seconds
Indefinitely Single read mode : reader will stay
on until a bar code is read.
Multiple read mode : reader will
stay on until power is recycled (not
recommended)
X1 No multiplication of read time
(default)
X10 Read time * 10
Version Information field which shows the bar code
readers firmware version.
RBAV01xx is used for 1D laser module.
FL23Jxx is used for 2D CMOS module.
If no version is displayed the bar code reader is
not found.
Note xx can have a value between 01 and 99.
Table 3-17 Basic TAB description
3.2.1.2 Code Configure TAB
In the Code Configure tab the bar code symbologies can be enabled or disabled.
It is strongly recommended to select only the required code. Advantages of selecting the
required codes are :
• faster reading,
• no accidental scanning of unwanted bar codes,
• reduced probability of reading errors which can not be prevented completely, because of
the limited security of some bar code types.
Bar code specific options can not be selected in this version of the Bar Code Settings tool.
In case bar code specific options are required, refer to Opticon’s Universal Menu Book,