Installation User Guide MODEL : AVHR-5000
- Content 1. General Information 1.1 Precautions 1.2 Features 2. System Components 3. Installation 3.1 Outside Antenna Installation 3.2 Inside Antenna Installation 3.3 Amplifier and Antenna Connection 3.4 Operating Instructions 4. Trouble Shooting 4.1 LED Alarm 4.2 Insufficient Outside Signal Problem 4.3 Vehicle Battery Discharge Problem 5. Specification 5.1 Amplifier Specification 5.2 Outside Antenna Specification 5.3 Inside Antenna Specification 5.4 Cigarette Power Code Specification 6.
1. General Information 1.1 Precautions Reference : Things you need to know to operate the product properly Caution : Things that you need to know not to damage the product Warning : Showing instructions for users to avoid unexpected hazard 1.1.1 Do not drop the device - Drop could damage the product 1.1.2 Do not place near magnetic - It could be cause of malfunction 1.1.3 Product is supposed to be used with the cigarette power code. If you want to use fuse cable, please ask professional installers. 1.1.
1.2 Features 1.2.1 Summary This product is installed on cars, trucks, trailers, boats and homes to improve user’s mobile phone signal. I. II. III. IV. Decrease dropped call Increase 2G/3G/4G data speed Battery life extension Voice quality improvement It is a RF type amplifier used for only CDMA Cellular bands in the 800MHz and PCS1900MHz . (Please see page 11 for Operating Frequency) 1.2.2 Features I. Strong coverage area - Gain 55dB II.
1.2.3 Installation 2. System Components ① Inside Antenna ② AVHR-5000 ④ cigarette power code ③ User Manual ⑤ Outsider Antenna ▣ System Components ① . Inside Antenna: connects signal between mobile phone and amplifier ②. AVHR-5000: amplifies signal from outside antenna which receives signal from a base station and sends amplified signal to mobile phone ③. User Manual: shows how to operate system ④. Cigarette Power Code : is the source of electricity ⑤.
3. Installation 3.1 Outside Antenna Installation 3.1.1 Outside antenna is magnetic. So you can mount on the roof of vehicle 3.1.2 Outside antenna should be distance at least 5 feet from inside antenna 3.1.3 As showing on the picture below, suggested place to mount outside antenna is rear end of roof Good Better Best 3.2 Inside Antenna Installation 3.2.1 Inside antenna is self adhesive. You can place it wherever you want 3.2.2 Before installation, please remove attached paper 3.2.
3.3 Amplifier and Antenna Connection 3.3.1 Place the amplifier under the seat or appropriate location. 3.3.2 Connect inside antenna connector to repeater 3.4 Operating Instructions 3.4.
3.4.2 Connect DC Jack as picture down below 3.4.3 Turn on the Switch as picture down below 3.4.
4. Trouble Shooing 4.1 LED Alarm GREEN LED RED LED 문제점 찾기 Setting/Resetting ON (after 3 times blinks) 3 times blinks See 4.1.1 Normal Mode ON OFF See 4.1.2 Overload Blink( once) - See 4.1.3 Oscillation Blink(twice) - See 4.1.4 Insufficient Isolation Blink(3 times) - See 4.1.5 Alarm Checking Blink(Consecutively) - See 4.1.6 Overload - Blink( once) See 4.1.3 Oscillation - Blink(twice) See 4.1.4 Insufficient Isolation - Blink(3 times) See 4.1.
4.1.5 ① There is a insufficient isolation between inside and outside antenna ② While installing if LED light blinks three times, move the inside and outside antenna away and turn on/off and move antenna as needed. ③ If there was no blinking problem while set up but happens after, it could be caused by surrounding structure but that could be come back to normal if you move to different location. 4.1.
5. Specification 5.1 Amplifier Specification Items Operating Frequency Cellular PCS Remarks Downlink 869 ~ 894 MHz 1930 ~ 1990 MHz CDMA Only Uplink 824 ~ 849 MHz 1850 ~ 1910 MHz CDMA Only Downlink 55dB±2.0dB 55dB±2.0dB Uplink 55dB±2.0dB 55dB±2.
5.2 Outside Antenna Specification Items Cellular PCS Remarks Operating Frequency 820 ~ 890 MHz 1710 ~ 1990 MHz - Bandwidth 70MHz 170MHz - Gain 5dBi - VSWR ≤ 2.0 : 1 - Impedance 50 Ω - Polarization Vertical - Connector FME(Female) - Antenna Length 28Cm - Weight 220g - Cable Length 5M - 5.3 Inside Antenna Specification Items Cellular PCS Remarks Operating Frequency 820 ~ 890 MHz 1710 ~ 1990 MHz - Bandwidth 70MHz 170MHz - Gain 2dBi - VSWR ≤ 2.
5.4.2 Output Specification Items Min Typical Max Normal DC Output Voltage - 6.0Vdc - DC Output Voltage Range 5.7Vdc - 6.3Vdc Load Current Range - - 3.5A Ripple - - 350mV Over Current Protection 4.2 - 7.0A Short Circuit Protection - Yes - 6. Certificates 6.1 FCC Certification ▪ Model : AVHR-5000 ▪ Certificate Data : 2011.03 ▪ Certificate No.: 6.2 IC Certification ▪ Model : AVHR-5000 ▪ Certificate Data : 2011.03 ▪ Certificate No.: 7.
7.