User's Manual

① Antenna
② LED display
③ Channel + key
④ Channel - key
/Call tone key
⑤ PTT key
⑥ ON/OFF key
⑦ Volume + key
⑧ Volume + key
/Lock key
⑨ Microphone
 Speaker
USER MANUAL
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
Changes or modifications to this unit not
expressly approved by the party responsible
for compliance could void the user’s authority
to operate the equipment.
Ver.01 Rev.MM/DD/YY
ONA19WT005
ONA19WT006
ONA19WT007
Model:
(1)
Ÿ Reorient or relocate the receiving antenna.
Ÿ Increase the separation between the equipment
and receiver.
Ÿ Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
Ÿ Consult the dealer or an experienced radio/TV
technician for help.
(1) this device may not cause harmful
interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
RF warning statement:
The device has been evaluated to meet general
RF exposure requirement.
The device can be used in portable exposure
condition without restriction.
(3)
(5) (6) (7)(4)
WARNING
1. Remove the battery cover.
2. Insert 3 AAA Alkaline Batteries with + and -
polarity as shown inside.
Installing the Batteries
3. Close the battery cover firmly.
Keypad Control and Function
Note: LED only display the channel
①
③
④
⑤
②
⑥
⑦
⑧
⑨
⑩
■ Battery Save
■ Auto Squelch Control
■ TOT (time-out timer)
■ Volume (0-7)
■ Low Battery Alert
■ 9 Channels
■ Keypad Lock
■ Auto power off (1.5h)
■ Keypad Tone
■ Call Roger Tone
■ 5 call tones for selection
Features
1. Press and hold [ ] key for 3 seconds to turn
the radio on or off.
Turn Radio On and Off
2. Upon power on, the radio chirps and briefly
shows all feature icons available on the radio.
3. The display screen then shows the current
channel, and all features that are enabled.
turn the radio
on or off
Remove the
battery cover
TIP1:
Insert 3 AAA
Alkaline
Batteries
TIP2:
Close the
battery
cover firmly
TIP3:
NOTE:
Do not hold the radio close to your ear, if the
volume is set to uncomfortable level, it could hurt
you hear.
Auto Power Off
If there is no response in 1.5 hour, the radio will
turn off automatically.
2. Press VOL[ / ] key to decrease the volume
level or mute the speaker.
Setting the Volume
1. Press VOL[ ] key to increase the volume
level.
Volume + key
Volume - key
/Lock key
1. Press CH [ ] key to increase the channel
number.
The channel is the frequency of radio uses to
transmit.
3. The radio has 9 channels.
Selecting the Channel
2. Press CH [ / ] key to decrease the channel
number.
Channel + key
Channel - key
/Call tone key
This product contains small parts such as
(batteries, battery cover and screws) that may
cause suffocation if swallowed by children.
NOTE:
Do not mix old and new batteries and Do not mix
alkaline, standard (carbon-zinc) or rechargeable
(ni-cad, ni-mh, etc.) batteries.
(2)