FCC Part 15.247 Certification Test Report FCC ID: R32-RFRCU FCC Rule Part: 15.247 ACS Report Number: 04-0170-15C Manufacturer: Onity, Inc. Equipment Type: Modular Radio Model: RFRCU Installation and Operators Guide 5015 B.U.
EUT – Product Manual Room Control Unit The Room Control Unit (RCU) is the ‘brain’ of Onity’s new Wireless Energy Management System(EMS). It receives the temperature, humidity, guest settings, fan mode, motion status, and door status from the various system devices and determines how to operate the HVAC system and lighting control.
RCU Buttons As stated above the RCU has 3 setup buttons. These are explained below. Configuration Button (CFG) The CFG button is used to configure the BFR (Building, Floor, Room) of the unit. At this time, the BFR is a randomly generated number. Press and hold the CFG button for 3 seconds, then release. Upon release, the red LED will flash once. Random numbers are generated to make the BFR and these are written to the radio. The radio then transmits an inquire message.
change unless the RCU receives a message indicating that no motion has been detected. The following list details the information the RCU will track from the wireless devices: • Temperature Setting • Room Temperature • On / Off status of WDDC • Fan button selection • Motion Status • Door Status (Interior and Exterior doors) • Battery Status of each device (for future use) The RCU expects to receive a status message from the WDDC at least once every 30 minutes.
thermostat settings. After 2 minutes have passed, the RCU checks the motion status of the room. The 2 minute delay ensures that the RCU does not have a false motion status as in the above example. If the motion status at the 2 minute point shows that motion has been detected, the room will lock into occupied mode and the 8 minute timer will stop.
The EUT utilizes a modular radio(FCC ID: R32-RFM100) and it has the following characteristics: 1) Federal Communication Commission Declaration of Conformity Statement This device complies with Part 15 Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interence, and 2. This device must accept accept any interference received, including interference that may cause undesired operation.
2) Canadian Compliance Statement This Class B digital apparatus meets all requirements of the Canadian Interference Causing Equipment Regulations. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. Cet appareillage numérique de la classe B répond à toutes les exigences de l'interférence canadienne causant des règlements d'équipement.
