User Instructions

ManualsBrandsOne And Done PRO ManualsElectronicsOne And Done PRO Remote Control

OneAndDone Pro Remote Control Instructions

The Remote Control Pack contains the following items:

1.The remote control unit (gray plastic box).

2.wireless remote(white remote) with a 12V battery.

This remote control unit is equipped with a connector for proper connection. Connect the

existing battery and motor, please follow the steps below;

1. SAE cable connected to Motor

2. 6.3mm Crimp Terminal Cable Female Connector battery

Summary of content (5 pages)

PAGE 1
OneAndDone Pro Remote Control Instructions The Remote Control Pack contains the following items: 1.The remote control unit (gray plastic box). 2.wireless remote(white remote) with a 12V battery. This remote control unit is equipped with a connector for proper connection. Connect the existing battery and motor, please follow the steps below; 1. SAE cable connected to Motor 2. 6.
PAGE 2
OneAndDone Pro Remote Control Command 1. Press the SET button to turn on the unit. When the device is turned on, “Time” will appear on the screen. Use the HR and MIN buttons to set the current time. Then press SET to confirm. 2. After confirmation, “Rotate 1-6” will appear on the screen. Use the HR and MIN buttons to set 6 different motor start times, then press “SET” to confirm. If you want to set less than 6 different start times, use the HR button to toggle until it shows "Off". 3.
PAGE 3
Wireless Remote Control Instructions
PAGE 4
1. Press the 2 button motor to start for 2 seconds. 2. Press the 5 button motor to start for 5 seconds. 3. Press the 10 button motor to start for 10 seconds. 4. Press the 20 button motor to start for 20 seconds.
PAGE 5
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.