Installation Manual

301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone [phone] / Fax [phone]
www.onqlegrand.com
Page 1 of 1
INSTRUCTION/INSTALLATION SHEET
6-Port Network Interface Module
IS-0355 REV. O
©Copyright 2006 by On-Q/Legrand All Rights Reserved.
1. Introduction
The On-Q/Legrand 6 Port Network Interface Module (P/N
AC1000) provides a convenient structured interconnect for
residential networking applications. The Network Interface
Module (see Figure 1) has six Category 5e rated RJ45
connectors which are typically connected (punched down)
to room locations. Services such as Internet access over
a switch/router are then jumpered to the locations using
the front panel jacks (jumpers available separately). The
module comes with a bracket and is typically mounted in
any On-Q Service Center Enclosure. In addition, mounting
can be done using the Bay style for higher density
applications in multi-bay brackets.
2. Description
The 6-Port Network Interface Module (P/N AC1000) consists of a bracket, a plate and six Category 5e rated
RJ45 Inserts.
NOTE: Part number AC1001 is also available (without inserts) to allow for the use of any dealer
selected Keystone inserts.
Cat 5e cables from the room locations are punched down onto the inserts following T568A recommendations
(see Figure 2). The use of a tool such as the On-Q Palm Tool (P/N 364378-01) is recommended to aid with
the punch down operation. The inserts are then installed into the plate (see Figure 3).
3. Installation
Once the RJ45 inserts have been punched down and installed into the plate, the plate may be installed into
an On-Q style enclosure by attaching the plate to the included bracket with push pins in each corner and
installing the bracket in the enclosure with the On-Q style tabs and pushpin. The plate may also be installed
in a Bay style multi-bay bracket.
Figure 2
Figure 1
Figure 3