Installation Manual

1. Introduction:

OnQ Video Modules (Figure 1) provide management and distribution of RF (Cable TV, DSS, etc.) signals on

coaxial cable throughout the house. The Video Modules provide for distribution of incoming cable service and a

convenient interface between the satellite dish antenna and two receiver boxes. The 2x6 and 3x8 models have

forward and reverse path amplification to provide unity gain throughout distribution. The 2x6 and 3x8 also pro-

vide for auxiliary inputs, such as CCTV or modulated media center input, which are combined with the cable

distribution. The modules can be mounted in any OnQ Service Center Enclosure.

2. Description:

The Video Modules have “F” style fittings for connecting all incoming and outgoing cables and power input with

LED when applicable. The 2x6 Video Module allows for 1 CATV input and 1 auxiliary input, the 3x8 Video

Module has two auxiliary inputs. The 2x6 and 3x8 Video Modules occupy 6 vertical inches on half the enclosure

width.

3. Installation

A. Mounting in enclosure (Figure 2)

1) Align tabs on module with slots on rail of enclosure.

2) Insert tabs by angling module away from the back of the

enclosure and sliding forward.

3) Rotate the module and insert fasteners on module into

corresponding holes on rail of enclosure. (Plunger must be in

the pulled out position for fastener to engage hole.)

4) Push plunger in to lock module in place. Pull on module

to assure module is locked properly in place.

Note: Recommended location for Video Modules is upper right side, however

modules may be mounted in any available space (Figure 3).

Note: Do not bend cable in less than about 2 inch radius.

B. Service Connection

1) Identify incoming service cable(s) and route to "Cable In" fitting(s) on module. In routing cable,

allow slack for bundling cables to the side. Trim cable to allow loose loop of cable to the

connection.

OnQ Technologies, Inc.

P.O. Box 60907

Harrisburg, PA 17106-0907

800-321-2343

www.onqtech.com

Installation/Instruction Sheet

OnQ Video Modules

IS-0013 Rev. E

IS-0013 Rev. E Page 1 of 2

2x6 Video Module - P/N 363468-02

Figure 2

3x8 Video Module - P/N 363469-02

Figure 1

PAGE 1
OnQ Technologies, Inc. P.O. Box 60907 Harrisburg, PA 17106-0907 800-321-2343 www.onqtech.com Installation/Instruction Sheet OnQ Video Modules IS-0013 Rev. E Figure 1 2x6 Video Module - P/N 363468-02 3x8 Video Module - P/N 363469-02 1. Introduction: OnQ Video Modules (Figure 1) provide management and distribution of RF (Cable TV, DSS, etc.) signals on coaxial cable throughout the house.
PAGE 2
OnQ Technologies, Inc. P.O. Box 60907 Harrisburg, PA 17106-0907 800-321-2343 www.onqtech.com C. D. E. Installation/Instruction Sheet OnQ Video Modules IS-0013 Rev. E 2) Attach an RG6 "F" connector to the cable. Connect to fitting on module and finger tighten. Satellite Connection 1) Identify cables from the satellite antenna and receiver outlets and route to appropriate fitting. In routing cable, allow slack for bundling cables to the side. Trim cable to allow a loose loop of cable to the connection.