User's Manual

ManualsBrandsOmron Automotive Electronics Korea ManualsElectronicsIMMOBILIZER

2. User's manual (provisionally)

2.1 NORMAL AUTHENTICATION

When IGN On, the EMS executes the key authentication after immobilizer authentication.

The Engine can be started in case authentication between immobilizer and Ignition key

(Transponder) succeeds. Normal authentication can be confirmed through the vehicle cluster

immobilizer LED ON.

Figure 2.1.1 Normal Authentication

2.2 AUTHENTICATION FAIL

Using invalid key to IGN on, Immobilizer LED blinks for 4.5 seconds as authentication fails.

Figure 2.2.1 Authentication Fail

- 2 –

Summary of content (4 pages)

PAGE 1
2. User's manual (provisionally) 2.1 NORMAL AUTHENTICATION When IGN On, the EMS executes the key authentication after immobilizer authentication. The Engine can be started in case authentication between immobilizer and Ignition key (Transponder) succeeds. Normal authentication can be confirmed through the vehicle cluster immobilizer LED ON. Figure 2.1.1 Normal Authentication 2.2 AUTHENTICATION FAIL Using invalid key to IGN on, Immobilizer LED blinks for 4.5 seconds as authentication fails. Figure 2.2.
PAGE 2
4. Specification 4.1 CPU Type R5F1096CJSP Manufacturer : Renesas ROM 32kB RAM 2kB Clock frequency 32MHz Clock frequency generation On-chip oscillator Package 20pin SSOP-B20 4.2 Others Dimension 73.9mm x 38mm x 24mm Weight 43g Battery CAR Battery (DC 12V) Operation Voltage, Current DC 12V, 6.
PAGE 3
5. Features 5.1 Unique electronic coded key 5.2 Embedded radio frequency (RF) transponder 5.3 Communicates with immobilizer via 125kHz carrier frequency 5.4 Stores secret key and performs other critical functions (User programmable 96-bit secret key) 5.5 Optional system communication via K-Line 5.6 Antenna rupture and short circuit detection 6. Derivatives Vehicle anti-theft systems. Using a transponder and an encrypted key code, the system authenticates users to enable or disable vehicle startup.
PAGE 4
FCC Part 15.19 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Part 15.21 Any changes or modifications (including the antennas) to this device that are not expressly approved by the manufacturer may void the user’s authority to operate the equipment.