User's Manual

ManualsBrandsOmega Analytics ManualsElectronicsOmegaWireless

Battery instructions

· Please do not make battery short-circuit, to avoid it damaged,

heat generationed and fired.

· Forbidden to put battery under high temperature or throw it into

fire to avoid explosion.

· Do not disassemble battery.

· If the battery will not be used for a period of time, please

discharge it and store it in a dry, dark, and cool place.

· Please stop using it when the battery and charger are damaged

or obviously aged.

· Please put the used batteries in the designated collection point,

and do not throw them away as ordinary garbage and pollute

the environment.

warn:

· If the battery is damaged, DO NOT contact with the substance

inside. If it is contaminated on the skin, rinse it with plenty of

water. If necessary, seek the help of a doctor.

Mobile Hotspot

User Manual

Thank you for choosing our product, please read this

manual carefully before using, follow the steps to use this

product, after reading, please keep it for future reference

Standard SIM card

※ Please insert standard sim, small card

can be restored with a card sleeve.

microSIM nanoSIM

SIM Card

Indicator light

How to insert SIM

5 seconds

micro SD

Slot

SIM Slot

Please pay attention

to the contacts of

the battery.

Remove the cover (there is a gap mouth in the

bottom left corner on the back)

Please turn off the device and remove battery,

then insert sim card. Please pay attention to the

direction of SIM card.

※There is a slot for micro SD card on the right.

After inserting SIM and battery correctly, press

power switch about 5 seconds to boot it, it can

be used normally.

Please put the original battery into the device

correctly, close the cover.

Blue on: WiFi is enabled, if disabled WiFi, light is off.

Blue flashing: data transmission

Blue on: new text messages received or unread messages

Blue flashing: SMS is full

Red flashing: charging

Red flashing & blue on: battery fully charged

Only blue on: sufficient power

Blue flashes slowly: low power

Blue flashes quickly: low battery, it’s about to

shut down

Shut

down

Boot

StatusLight

Flashing blue: Network connected successfully.

Steady blue: Data is disconnected.

Steady red: 1. The device is powered on;

2. SIM is not detected or there is no network

or other error states.

Signal

status

WiFi status

SMS status

Power

status

Red flashing: charging

Steady red: battery is fully charged

Summary of content (4 pages)

PAGE 1
Mobile Hotspot How to insert SIM SIM Card Standard SIM card microSIM nanoSIM Remove the cover (there is a gap mouth in the bottom left corner on the back) User Manual Battery instructions · Please do not make battery short-circuit, to avoid it damaged, heat generationed and fired. · Forbidden to put battery under high temperature or throw it into fire to avoid explosion. · Do not disassemble battery.
PAGE 2
How other devices connect the network? How to insert micro SD please insert micro SD directly without bending or tilt micro SD Slot Choose one of the following methods to connect to the Internet. By WPS Long press WPS button to turn it on for quick connection (refer to the below image) Device Management Find the WiFi name Recommended connected method In the boot-up state, networking devices can connect to the default WiFi transmitted by the device for wireless Internet access.
PAGE 3
FCC STATEMENT : This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
PAGE 4
SAR Information Statement The product is designed and manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications Commission of the U.S. Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies.