Installation & Assembly

INSTALLATION
Tools:
Adjustable Wrench Plumbers Putty Sealant Tape Rags
Model Number: L-7470, L-7472 (CP, PVD BN,
ORB)
Warnings and Notes:
Check with local plumbing code requirements before installation.
This product should be installed by a local listed plumber.
Do not use plumbers putty on threads.
OLYMPIA FAUCETS, INC.
Interchange City Distribution Center #20
1277 Heil Quaker Boulevard
La Vergne, TN 37086
[phone]
www.olympiafaucets.com
Installation Steps:
Two Handle Lavatory Widespread Faucet
(1) Shut off water supplies. Remove old faucet.
Clean mounting surface in preparation for new
faucet.
(2) Ensure there is a washer under the spout
ange. Place the spout in position on the sink.
From under the sink slide mounting bracket
through spout shank. Thread nut onto spout
shank properly and tighten nut
(3) Thread “Y” connector to the spout shank.
Ensure there is a washer in the “Y” connector.
Do not overtighten.
(4) Thread valve ange to valve. Install Cold
and hot handle to the valve with the help of
3/32” Allen wrench. Place hot and cold side
valve in position on the sink. Ensure handles
turns in correct direction.
(5) From under the sink place washers and
thread locknut with the help of 1-11/32” size
socket. Connect outlet hose to Y connector.
Connect inlet tube to water supply.
(1) Remove pop-up ange from body
(2) Place a ring of putty on the bottom of
ange.
(3) Insert pop-up ange through drain
hole and attach ange to body. Ensure
the pop-up outlet faces towards the sink.
Do not overtighten.
Pop-up Drain Installation:
(6) Turn on water supplies. Check for
any minor joint leaks. Remove aerator
from spout by turning counterclockwise.
Turn on both side handles. Flush and
allow water to run at full ow at least
one minute. Turn off both side handles.
Replace aerator