User's Manual

ManualsBrandsOKIN Refined Electric Technology ManualsElectronicsWireless remote handset

OKIN Refined Electric Technology Co., Ltd

Page 1 of 5

Operating Manual of Remote Hand Control

1、Interface of the Handset

2、Button description

button: Press the button, the head and foot motor will move simultaneously and

do not stop until return to the position of the system set (reading position). You can press

any button to stop action during moving.

button: Press the button, the head and foot motor will move simultaneously and

do not stop until return to the position of the system set (recline position). You can press

any button to stop action during moving.

button: Press the button, the head and foot motor will move simultaneously and

do not stop until return to the position of the system set (zero gravity position). You can

press any button to stop action during moving.

The reading, recline and zero gravity position can be changed by the end user.

Step 1: Adjust the head position and feet position to a desired position;

Step 2: Press and hold the

button for 3sec, backlight LED start flashing;

Step 3: Release

button, during next 1sec, press or or

button, LED stop flashing. Then the corresponding position is updated successfully.

Summary of content (5 pages)

PAGE 1
OKIN Refined Electric Technology Co., Ltd Operating Manual of Remote Hand Control 1、Interface of the Handset 2、Button description A. button: Press the button, the head and foot motor will move simultaneously and do not stop until return to the position of the system set (reading position). You can press any button to stop action during moving. B. button: Press the button, the head and foot motor will move simultaneously and do not stop until return to the position of the system set (recline position).
PAGE 2
OKIN Refined Electric Technology Co.,Ltd D. HEAD button：Press and hold the button, the head motor will go up or down. E. FEET button：Press and hold the button, the foot motor will go up or down. FLAT button：Press the button, the head and foot motor will move down to the flat F. position simultaneously. You can press any button to stop action during moving. G. H.
PAGE 3
OKIN Refined Electric Technology Co.,Ltd The blue LED on-------20minutes Both of the yellow LED and the blue LED on-------30minutes Both of the yellow LED and the blue LED off-------forever 3、Wireless Matching operation Step 1: Set up DIP switch to a desired channel; The below is only for example.
PAGE 4
OKIN Refined Electric Technology Co.,Ltd Step 3: Two seconds later connect again the DC plug of the control box to the SMPS to turn on the power. Step 4: Press simultaneously and hold the head up button and feet up button on the handset until backlight LED flashing. Release the two buttons and LEDs continue flashing and search with control box, once the LEDs stop flashing the matching is successful, which means the control box and the handset can work together.
PAGE 5
OKIN Refined Electric Technology Co.,Ltd 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.