Installation Manual



RFI D ( 4336821A)  i nst al l at i on procedure.

Plate-Inner

Plate-Shield-RFID

1. To assemble Board-RFID to Plate-Shield-RFID

with two screws.

※ RFID Assy – PCB

2. To assemble RFID Assy-PCB to Plate-Inner with

two screws.

Film

Board-RFID

after assembly

※ Plate Assy – Inner (4336821A)

A toner cartridge is equipped with RF-ID TAG.

If toner cartridges are set to a printer, communication of RF-ID TAG and a RFID read writer module will be attained.

The function of this system is the following: Management of the existence detection and toner residual quantity of a toner cartridge.

4336821A are attached printer base unit according to the following figure.

RFID (4336821A) installation procedure

PAGE 1
RFID (4336821A) installation procedure A toner cartridge is equipped with RF-ID TAG. If toner cartridges are set to a printer, communication of RF-ID TAG and a RFID read writer module will be attained. RFIfunction D ( 4336821A) l at i on pr ocedur e. existence detection and toner residual quantity of a toner cartridge. The of this systemiisnst the al following: Management of the 4336821A are attached printer base unit according to the following figure. 1. 2.
PAGE 2
To assemble Head-Cable, Holder-Head, Cover–Top(Sub) and etc to Plate Assy – Inner (4336821A) with 8 screws.
PAGE 3
To assemble Cover Assy –Top to Printer-Unit.
PAGE 4
FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.