User's Manual

Manual
Wireless Bodypack Transmitter
12
13
10
11
3
4
1
2
POWER / MUTE switch
(MUTE indicator)
Channel / Volume switch
LCD screen
Mesh head
(hidden microphone)
5
6
7
9
10
11
8
12
13
External mic. Input
Hidden charging indicator
Aux input
Neck Strap hole
DC charging input
Strap hole
Neck strap
Buckle clip
Charging terminal
Charging mode
1. LED lights red when charging.
2. LED lights green when battery is fully charged.
3. When device is slot into a charger stand, will off the power.
4. Battery error: LED status lights red and flashes when charging,
LCD battery symbol lights flashes, and it caused by:
(1)The battery charge temperature is exceeded 60 C
o
.
(2)The duration of charging time for charger stand is exceeded
seven hours.
(3)The battery is defected.
Frequency synchronization
1. When processing frequency synchronization, the green charging
indicator will be blinking while use a 20 slot charger or a 30 slot
charger. LCD screen will then display the current charging status.
2. The device can repeat synchronization by a charger.
Others
To reset mode, press / at th e same time an d switch the po wer
on.
Notice: The ch anges or mo difications not expressly approved by th e party re sponsible for co mpliance
could vo id th e user’s authority to op erate the equipme nt.
IMP ORTANT NOTE: To comply with the FC C RF exposure comp liance requirement s, no c hange to th e
ant enna or the device is p ermitted. Any ch ange to th e an tenna or t he de vice co uld
result in t he de vice exc eeding th e RF exposure requirements an d void user’s
authority to op erate the de vice.
Consume r Alert
Most users do no t need a license to op erate this wireless microphone system. N evertheless, op erating
this microphone system wi thout a license is s ubject to ce rta in re strictions: Th e system ma y not cause
harmful interference; it mu st operate at a low power le vel (not in exc ess of 5 0 milliwatts); an d it has no
protection from interference re ceived from any other device. Purchasers sh ould also be aw are th at th e
FCC is current ly ev aluating us e of wi reless mi crophone sy stems , and these rules ar e subject to ch ange.
For more informa tion, ca ll th e FCC at 1– 888–CALL–FCC (T TY: 1– 888–TELL–FCC) or visit th e FCC’s
wireless microphone Web site at ht tp://www.f cc.gov/c gb/wirelessmi crophones.
3
4
5
1
2
6
7
9
8
Wireless Bodypack Transmitter
Set up/ Installation
1. Press and hold for 0.5 second and the power is on.
LCD backlit lights up.
2. When power is on, the button lights blue.
3. Power is on in two seconds and receiving audio signal.
Power ON
Power OFF
1. Press and hold for two seconds to turn the device off.
2. OFF display on screen and all indicators turned off.
1. Press and hold SET button for two seconds; ent er into the
2. When channel numbers flashes, press or to select
prefer red channel. To con firmed, pres s SE T bu tton .
Channel select
channel select mode.
Mute / Talk select
1. Press Mute button for two seconds; enter into the Mute
/ Talk switch mode.
2. Mute mode: LED lights red. Talk mode: LED lights blue.
Select output power/
Maximum available channels
1. On OFF mode, press SET and POW ER button to enter into
2. LCD screen will display ma ximum available channels; 640
-664 MHz, 794-806 MH z and 863-865 MH z. Press or
to select preferred channel.
3. Press SET button to confirm and select, or it will confirm
4. LCD screen will display Hi / Lo, press or to select
5. Press SET button to confirm and select or to wait for 5
the selection mo de.
in 5 seconds without any key s pressed.
preferred output powe r.
seconds without any key s pressed.
Channel display
Press SET button to display the current used frequency.
Volume switch
LCD screen will display current used volume level when press
or (VOL. 1 3).～
Manual
Wireless Bodypack Receiver
14
12
11
13
3
4
5
1
2
6
9
10
8
7
Wireless Bodypack Receiver
3
4
1
2
MUTE switch
(MUTE indicator)
Channel switch
LCD screen
Built-in speaker
5
6
7
9
10
11
8
12
Neck strap
Earphone output jack
Charging indicator
POWER / VOLUME knob
AUX output
13
14
Buckle clip
Charging terminal
Strap hole
DC charging input
Strap hole
Specifications are subject to ch ange wi thout pr ior notice.
※
Set up/ Installation
1. Turn on the power switch knob by clockwise and power
is on.
2. When power is on, it will display available channel
number.
Power ON
Power OFF
1. Turn off the power switch knob by anti-clockwise, and
the device off
2. OFF display on screen and all indicators turned off.
Channel display
LCD is display channel status; press SET button to display
the current used frequency.
off with out receivin g audio sig nal when exceeded upto ten
succeed frequency synchronizatio n and MUTE button indica tor
charging indica tor will be blinking at least ten tim es while
use a 20 slo t charger or a 30 slo t charger. LCD screen wil l
Frequency synchronization
1. When pow er is on, it wil l synchroni ze frequenc y or swi tch
minutes . When synchroni zati on, MUTE indi cator lights bl ue
2. The devi ce will automati cally swi tch to MUTE mode when
3. When proces sing frequenc y synchroni zati on, the green
and flashes and LCD back lit lights up.
then displ ay the cur rent char ging stat us.
4. The devi ce can repeat synchroni zati on by a char ger.
Power off automatically
Power will off automatically without receiving audio
signals; LCD screen and indicators off.
Mute / Listen select
1. Press MUTE button, enter into Mute / Listen select mode.
2. Mute LED lights flashes again when receiving RF signal.
3. Mute LED lights steady when receiving no signal.
4. When Listen mode is receiving signal again; Mute LED lights
blue and steady.
5. When Listen mode is receiving no signal; Mute LED lights off.
Charging mode
1. LED lights red when charging.
LED lights green when battery is fully charged.
2. When device is slot into a charger stand, will off the power.
3. Battery error: LED status lights red and flashes when charging,
LCD battery symbol lights flashes, and it caused by:
o
(1)The battery charge temperature is exceeded 60 C
(2)The duration of charging time for charger stand is exceeded
seven hours.
(3)The battery is defected.
.
Others
To reset mode, press / at th e same time an d switch the po wer
on.
Channel select
Press / to select preferred channel.
Volume select
Adjust volume level by rotate and clockwise the knob.
lights red.
08/1408/14